Oxidative diamination promoted by dinuclear iodine(III) reagents

Iodometry and iodimetry are analytical methods used to determine the concentration of oxidizing or reducing agents using iodine. In iodometric titrations, the oxidizing analyte solution is usually acidified and treated with an excess of iodide ions, which generates an equivalent amount of iodine in equilibrium with triiodide. The released iodine is subsequently titrated directly against a standardized reducing agent. As the dilute iodine color becomes pale yellow, a few drops of freshly...

Besides iodine, other oxidizing or reducing agents can serve as titrants in redox titrations. Common oxidizing titrants include KMnO4, cerium(IV), and K2Cr2O7. The choice of oxidizing titrants depends on factors like stability, cost, analyte strength, and reaction rate between the analyte and titrant. KMnO4 is a strong oxidizing titrant that reduces from Mn(VII) to Mn(II) in a highly acidic solution, simultaneously oxidizing the analyte to a higher oxidation state. In this case, KMnO4 acts as a...

Alkenes are converted to 1,2-diols or glycols through a process called dihydroxylation. It involves the addition of two hydroxyl groups across the double bond with two different stereochemical approaches, namely anti and syn. Dihydroxylation using osmium tetroxide progresses with syn stereochemistry.

Diols are compounds with two hydroxyl groups. In addition to syn dihydroxylation, diols can also be synthesized through the process of anti dihydroxylation. The process involves treating an alkene with a peroxycarboxylic acid to form an epoxide. Epoxides are highly strained three-membered rings with oxygen and two carbons occupying the corners of an equilateral triangle. This step is followed by ring-opening of the epoxide in the presence of an aqueous acid to give a trans diol.

Bromination and chlorination of aromatic rings by electrophilic aromatic substitution reactions are easily achieved, but fluorination and iodination are difficult to achieve. Fluorine is so reactive that its reaction with benzene is difficult to control, resulting in poor yields of monofluoroaromatic products. To address this, Selectfluor reagent is used as a fluorine source in which a fluorine atom is bonded to a positively charged nitrogen.

Activated manganese(IV) oxide can selectively oxidize allylic and benzylic alcohols via a radical intermediate mechanism. Primary allylic alcohols are oxidized to aldehydes, while secondary allylic alcohols yield ketones. The redox reaction of potassium permanganate with an Mn(II) salt such as manganese sulfate (under either alkaline or acidic conditions), followed by thorough drying, yields the oxidizing agent: activated MnO2. While MnO2 is insoluble in the solvents used for the reaction, the...