Related Experiment Video

Updated: May 14, 2026

PDMS Device Fabrication and Surface Modification
14:48

PDMS Device Fabrication and Surface Modification

Published on: October 1, 2007

Design transfer and design for manufacturability [senior design]

Jay Goldberg

    IEEE Pulse
    |February 16, 2013
    PubMed

    More Related Videos

    High Throughput Microfluidic Rapid and Low Cost Prototyping Packaging Methods07:51

    High Throughput Microfluidic Rapid and Low Cost Prototyping Packaging Methods

    Published on: December 23, 2013

    Related Concept Videos

    Design Consideration01:22

    Design Consideration

    Designing a structure involves a series of considerations, primarily the material's ultimate strength, calculated through tests that measure changes under increased force until the material reaches its breaking point or limit. The ultimate load, where the material breaks, is divided by its original cross-sectional area, resulting in the ultimate normal stress or strength. The ultimate shearing stress is another significant factor taken into account.
    The factor of safety is another key aspect...
    Dimensional Analysis01:27

    Dimensional Analysis

    Dimensional analysis is a valuable technique in fluid mechanics for simplifying complex problems by reducing them into dimensionless groups. These groups capture the essential relationships between the variables involved, allowing researchers and engineers to analyze fluid flow without dealing with each variable individually. This approach reduces the number of independent variables, allowing for easier analysis and better understanding of physical phenomena.
    In fluid mechanics, dimensional...
    Methods of Medium Optimization01:28

    Methods of Medium Optimization

    Optimizing growth media enhances microbial proliferation and maximizes product yield. Statistical experimental design methodologies provide structured and reproducible approaches, offering progressively higher levels of robustness and efficiency.The One-Factor-at-a-Time (OFAT) MethodThe One-Factor-at-a-Time (OFAT) method involves adjusting a single variable while keeping all others constant. However, it cannot detect interactions between variables, often leading to suboptimal outcomes when...
    PD Controller: Design01:26

    PD Controller: Design

    In automotive engineering, car suspension systems often employ Proportional Derivative (PD) controllers to enhance performance. PD controllers are utilized to adjust the damping force in response to road conditions. A controller, acting as an amplifier with a constant gain, demonstrates proportional control, with output directly mirroring input.
    Designing a continuous-data controller requires selecting and linking components like adders and integrators, which are fundamental in Proportional,...
    Design Example: Resistive Touchscreen01:14

    Design Example: Resistive Touchscreen

    A device engineer plays a crucial role in designing user interfaces for mobile devices. One such interface is the resistive touchscreen, which fundamentally consists of two metallic layers: a flexible upper layer and a rigid lower layer, separated by a narrow gap. The high resistance between these two layers is a key characteristic of this design.
    When a user touches the screen, the two layers make contact at a specific point known as the touchpoint. This contact reduces the resistance between...