Related Experiment Videos

Hardware implementation of Lorenz circuit systems for secure chaotic communication applications

Hsin-Chieh Chen1, Ben-Yi Liau, Yi-You Hou

  • 1Department of Biomedical Engineering, Hungkuang University, Taichung 43302, Taiwan. hcchen@sunrise.hk.edu.tw

Sensors (Basel, Switzerland)
|February 23, 2013
PubMed
Summary

This study demonstrates Lorenz chaotic system synchronization using a novel slide mode controller (SMC). The proposed proportional-integral (PI) switching surface enables secure communication system construction and experimental validation.

Related Concept Videos

RL Circuits01:14

RL Circuits

An RL circuit consists of a resistor and an inductor and may have a source of emf connected to it. The inductor in the circuit helps to prevent rapid changes in current, which can be helpful if a steady current is required but the external source has a fluctuating emf. Consider an open RL circuit connected to a source of constant emf. As soon as the circuit is closed, the current begins to increase at a rate that depends only on the value of the inductance in the circuit. The greater the...
Classification of Systems-I01:26

Classification of Systems-I

Linearity is a system property characterized by a direct input-output relationship, combining homogeneity and additivity.
Homogeneity dictates that if an input x(t) is multiplied by a constant c, the output y(t) is multiplied by the same constant. Mathematically, this is expressed as:
Second-Order Circuits01:17

Second-Order Circuits

Integrating two fundamental energy storage elements in electrical circuits results in second-order circuits, encompassing RLC circuits and circuits with dual capacitors or inductors (RC and RL circuits). Second-order circuits are identified by second-order differential equations that link input and output signals.
Input signals typically originate from voltage or current sources, with the output often representing voltage across the capacitor and/or current through the inductor. For example, in...
BIBO stability of continuous and discrete -time systems01:24

BIBO stability of continuous and discrete -time systems

System stability is a fundamental concept in signal processing, often assessed using convolution. For a system to be considered bounded-input bounded-output (BIBO) stable, any bounded input signal must produce a bounded output signal. A bounded input signal is one where the modulus does not exceed a certain constant at any point in time.
To determine the BIBO stability, the convolution integral is utilized when a bounded continuous-time input is applied to a Linear Time-Invariant (LTI) system.
First-Order Circuits01:15

First-Order Circuits

First-order electrical circuits, which comprise resistors and a single energy storage element - either a capacitor or an inductor, are fundamental to many electronic systems. These circuits are governed by a first-order differential equation that describes the relationship between input and output signals.
One common example of a first-order circuit is the RC (resistor-capacitor) circuit. These circuits are used in relaxation oscillators such as neon lamp oscillator circuits. When voltage is...
Linear time-invariant Systems01:23

Linear time-invariant Systems

A system is linear if it displays the characteristics of homogeneity and additivity, together termed the superposition property. This principle is fundamental in all linear systems. Linear time-invariant (LTI) systems include systems with linear elements and constant parameters.
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be calculated...