Surface topographic characterization for polyamide composite injection molds made of aluminum and copper alloys

In order to ensure flexibility and rapid new product development, the mold industry made use of soft materials for cavity inserts in injection molds. However, materials of this kind are prone to wear. This article analyzes the topographic characterization of the surface and wear processes in injection molds cavities. Two materials have been used to produce the cavities: aluminum alloy EN AW‐6082 T4 and copper alloy Cu Zn39 Pb3. The surface topography was measured with the use of optical interferometry profiling technology; roughness and surface parameters were determined according to ISO 4287, ISO 25178, and EUR 15178N. In order to complete this research, an experimental part with different thicknesses and shapes was designed, and cavity inserts of aluminum and copper were made. Polyamide PA6, with 30% fiberglass reinforcement, was employed in the experimental procedure. Measurements of cavity mold surfaces were performed after 9,200 cycles on each mold and at different locations on the mold. The surface measurement was made with a white light vertical scanning interferometry, also known as coherence scanning interferometry (ISO DIS 25178‐604). The results are analyzed and differences between the two types of cavity inserts materials are discussed.