Fixed or mixed: a comparison of three, four and mixed-option multiple-choice tests in a Fetal Surveillance Education

Nathan Zoanetti1, Mark Beaves, Patrick Griffin

  • 1Assessment Research Centre, Melbourne Graduate School of Education, University of Melbourne, Parkville, Australia.

BMC Medical Education
|March 5, 2013
PubMed
Abstract

Related Concept Videos

Multiple Comparison Tests01:13

Multiple Comparison Tests

Multiple comparison test, abbreviated as MCT, is a post hoc analysis generally performed after comparing multiple samples with one or more tests. An MCT will help identify a significantly different sample among multiple samples or a factor among multiple factors.
It would be easy to compare two samples using a significance alpha level of 0.05. In other words, there is only one sample pair to be compared. However, it would be difficult to identify a significantly different sample if the number...
Cochran's Q Test01:17

Cochran's Q Test

Cochran's Q Test is a nonparametric statistical test used to determine if there are potential differences in the outcomes of three or more related groups on a binary (yes/no) or dichotomous outcome. It is essentially an extension of the McNemar Test, which is limited to two related samples - Cochran's Q test can handle three or more related samples, making it more versatile in scenarios where subjects are measured under multiple conditions. The test statistic follows a Chi-Square distribution,...
McNemar's Test01:23

McNemar's Test

McNemar's Test is a nonparametric statistical test used to determine if there is a significant difference in proportions between two related groups when the outcome is binary (e.g., yes/no, success/failure). It is beneficial when we have paired data, such as pre-test/post-test designs, where the same subjects are measured under two different conditions. The test is named after the statistician Quinn McNemar, who introduced it in 1947. It is commonly used in situations where subjects are...
Bonferroni Test01:10

Bonferroni Test

The Bonferroni test is a statistical test named after Carlo Emilio Bonferroni, an Italian mathematician best known for Bonferroni inequalities. This statistical test is a type of multiple comparison test to determine which means are different than the rest. Bonferroni test can minimize the Type 1 error by reducing the significance level alpha, which otherwise increases with sample pairs.
The means of different samples are first paired in all possible combinations.
The null hypothesis of the...
Comparing Experimental Results: Student's t-Test01:09

Comparing Experimental Results: Student's t-Test

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...
Bioequivalence Experimental Study Designs: Repeated Measures, Cross-Over, Carry-Over, and Latin Square Designs01:15

Bioequivalence Experimental Study Designs: Repeated Measures, Cross-Over, Carry-Over, and Latin Square Designs

Bioequivalence experimental study designs play a pivotal role in testing the effectiveness of various treatments. Key among these are the repeated measures, cross-over, carry-over, and Latin square designs. In the repeated measures design, each subject receives all treatments, allowing for temporal comparisons. This type of design is useful in reducing variability but requires careful planning to avoid bias.The cross-over design, an economical method, involves sequential administration of...