Related Experiment Video
Updated: May 13, 2026

Monitoring Lung Function with Electrical Impedance Tomography in the Intensive Care Unit
Published on: September 6, 2024
Mechanical ventilation guided by electrical impedance tomography in experimental acute lung injury
Gerhard K Wolf1, Camille Gómez-Laberge, Jordan S Rettig
1Department of Anesthesiology, Perioperative and Pain Medicine, Division of Critical Care Medicine, Boston Children's Hospital, Harvard Medical School, Boston, MA, USA. gerhard.wolf@childrens.harvard.edu
Objective:
To utilize real-time electrical impedance tomography to guide lung protective ventilation in an animal model of acute respiratory distress syndrome.
Design:
Prospective animal study.
Setting:
Animal research center.
Subjects:
Twelve Yorkshire swine (15 kg).
Interventions:
Lung injury was induced with saline lavage and augmented using large tidal volumes. The control group (n = 6) was ventilated using ARDSnet guidelines, and the electrical impedance tomography-guided group (n = 6) was ventilated using guidance with real-time electrical impedance tomography lung imaging. Regional electrical impedance tomography-derived compliance was used to maximize the recruitment of dependent lung and minimize overdistension of nondependent lung areas. Tidal volume was 6 mL/kg in both groups. Computed tomography was performed in a subset of animals to define the anatomic correlates of electrical impedance tomography imaging (n = 5). Interleukin-8 was quantified in serum and bronchoalveolar lavage samples. Sections of dependent and nondependent regions of the lung were fixed in formalin for histopathologic analysis.
Measurements And Main Results:
Positive end-expiratory pressure levels were higher in the electrical impedance tomography-guided group (14.3 cm H₂O vs. 8.6 cm H₂O; p < 0.0001), whereas plateau pressures did not differ. Global respiratory system compliance was improved in the electrical impedance tomography-guided group (6.9 mL/cm H₂O vs. 4.7 mL/cm H₂O; p = 0.013). Regional electrical impedance tomography-derived compliance of the most dependent lung region was increased in the electrical impedance tomography group (1.78 mL/cm H₂O vs. 0.99 mL/cm H₂O; p = 0.001). Pao₂/FIO₂ ratio was higher and oxygenation index was lower in the electrical impedance tomography-guided group (Pao₂/FIO₂: 388 mm Hg vs. 113 mm Hg, p < 0.0001; oxygentation index, 6.4 vs. 15.7; p = 0.02) (all averages over the 6-hr time course). The presence of hyaline membranes (HM) and airway fibrin (AF) was significantly reduced in the electrical impedance tomography-guided group (HMEIT 42% samples vs. HMCONTROL 67% samples, p < 0.01; AFEIT 75% samples vs. AFCONTROL 100% samples, p < 0.01). Interleukin-8 level (bronchoalveolar lavage) did not differ between the groups. The upper and lower 95% limits of agreement between electrical impedance tomography and computed tomography were ± 16%.
Conclusions:
Electrical impedance tomography-guided ventilation resulted in improved respiratory mechanics, improved gas exchange, and reduced histologic evidence of ventilator-induced lung injury in an animal model. This is the first prospective use of electrical impedance tomography-derived variables to improve outcomes in the setting of acute lung injury.
Related Concept Videos
Mechanical Ventilation II: Invasive Ventilation
Negative-Pressure Ventilators
Negative-pressure ventilators create a vacuum around the chest or body to draw air into the lungs, simulating breathing. This method does not require an...
Mechanical Ventilation I: Indication and Settings
Mechanical Ventilation III: Noninvasive Ventilation
Noninvasive Positive-Pressure Ventilation (NIPPV)
Acute Respiratory Failure-V
Ensure that patients are monitored continuously for their response to therapy, including changes in...
Ventilatory Modes
There are three ventilatory modes: full support, partial support, and spontaneous. These are described below.
Full Support Modes
Full support modes include controlled mechanical ventilation, continuous mandatory...
