2-[1-(2-Hy-droxy-6-meth-oxy-phen-yl)ethyl-idene]-N-methyl-hydrazinecarbothio-amide acetonitrile monosolvate

Structure of Carboxylic Acid Derivatives
Carboxylic acid derivatives contain an acyl group attached to a heteroatom such as chlorine, oxygen, or nitrogen. The carbonyl carbon and oxygen are both sp2-hybridized with an unhybridized p orbital.
The three sp2 orbitals of the carbonyl carbon form three σ bonds, one each with the carbonyl oxygen, the α carbon, and the heteroatom, whereas the other two sp2 orbitals of the carbonyl oxygen are occupied by the lone pairs. Further, the unhybridized p...

Nitriles undergo acid-catalyzed hydrolysis or base-catalyzed hydrolysis to form a carboxylic acid. These reactions proceed via an amide intermediate.

Amides can undergo either acid-catalyzed hydrolysis or base-promoted hydrolysis through a typical nucleophilic acyl substitution. Each hydrolysis requires severe conditions.
Acid-catalyzed hydrolysis:
Hydrolysis of amides under acidic conditions yields carboxylic acids. Since the reaction occurs slowly, hydrolysis requires the conditions of heat.
The mechanism begins with the protonation of the carbonyl oxygen by the acid catalyst. The protonation makes the amide carbonyl carbon more...

An oxygen-based nucleophile, like water, can undergo addition reactions with aldehydes and ketones. The reaction leads to the formation of hydrates, also referred to as 1,1-diols or geminal diols.
The formation of hydrates is a reversible reaction. Hydrate formation is influenced by steric and electronic factors accompanying the alkyl substituents on the carbonyl group: The rate of hydrate formation increases with a decrease in the number of alkyl groups attached to the carbonyl carbon. Hence,...

Naming Amides
The IUPAC and common names of amides are derived from the parent carboxylic acid, by replacing the suffix “oic acid” and “ic acid,” respectively, with “amide.” In the following example, the IUPAC name ethanamide is derived from ethanoic acid, and the common name, acetamide, is obtained from acetic acid.

The acidic strength of hydrocarbons follows the order: Alkynes > Alkenes > Alkanes. The strength of an acid is commonly expressed in units of pKa — the lower the pKa, the stronger the acid. Among the hydrocarbons, terminal alkynes have lower pKa values and are, therefore, more acidic. For example, the pKa values for ethane, ethene, and acetylene are 51, 44, and 25, respectively, as shown here.