Active slag filters: rapid assessment of phosphorus removal efficiency from effluent as a function of retention time

There is increasing pressure to upgrade effluent ponds for phosphorus removal. Active slag filters offer a solution, but design information is limited. Hydraulic retention time (HRT) is a key factor in filter design because it controls filter treatment efficiency as well the filter substrate lifespan. This paper reports on a rapid method of continual looping of effluent through a filter column to obtain a relationship between HRT and phosphorus removal efficiency. Phosphorus removal declined logarithmically with respect to retention time. While the mechanisms that yield this relationship involve complex mass transfer and adsorption of phosphorus to Fe oxyhydroxide sites, in general terms, the adsorption rate is proportional to the adsorbate effluent concentration. Waste stabilization pond effluent treated by the slag achieved phosphorus removal efficiencies over 90% at extended HRTs greater than 70 hours, while 80% removal was obtainable in 30 hours. Higher phosphorus removal was achieved for slag treating real effluent compared with synthetic phosphate solution. This can be explained by: (1) different starting phosphorus concentrations in the synthetic phosphate solution and real effluent; and (2) the presence of constituents in real effluent that can enhance phosphorus removal, such as oxidized iron compounds, cations, algae and humic complexes. This new technique, which proved capable of replicating treatment efficiencies obtained from long-term column studies, offers rapid assessment of phosphorus removal efficiency as a function of retention time and thus will enable design engineers to size active filters on the basis of achieving the required phosphorus removal standards.