Related Experiment Video

Updated: May 12, 2026

Magnetometric Characterization of Intermediates in the Solid-State Electrochemistry of Redox-Active Metal-Organic Frameworks
06:53

Magnetometric Characterization of Intermediates in the Solid-State Electrochemistry of Redox-Active Metal-Organic Frameworks

Published on: June 9, 2023

Dosimeter-type NOx sensing properties of KMnO4 and its electrical conductivity during temperature programmed

Andrea Groß1, Michael Kremling, Isabella Marr

  • 1Zentrum für Energietechnik, Bayreuth Engine Research Center (BERC), Department of Functional Materials, University of Bayreuth, 95440 Bayreuth, Germany. andrea.gross@uni-bayreuth.de

Sensors (Basel, Switzerland)
|April 4, 2013
PubMed

More Related Videos

Assessment of Boron Doped Diamond Electrode Quality and Application to In Situ Modification of Local pH by Water Electrolysis13:09

Assessment of Boron Doped Diamond Electrode Quality and Application to In Situ Modification of Local pH by Water Electrolysis

Published on: January 6, 2016

Estimating Sediment Denitrification Rates Using Cores and N2O Microsensors07:59

Estimating Sediment Denitrification Rates Using Cores and N2O Microsensors

Published on: December 6, 2018

Related Concept Videos

Flame Photometry: Lab01:16

Flame Photometry: Lab

In a flame photometer, when a solution like potassium chloride is aspirated into the flame, the solvent evaporates, leaving behind dehydrated salt. This salt dissociates into free gaseous atoms in their ground state. Some of these atoms absorb energy from the flame, leading to their excitation. The excited atoms return to the ground state, emitting photons at characteristic wavelengths. Because only electronic transitions are involved, the resulting emission lines are very narrow. The intensity...
Redox Titration: Other Oxidizing and Reducing Agents01:26

Redox Titration: Other Oxidizing and Reducing Agents

Besides iodine, other oxidizing or reducing agents can serve as titrants in redox titrations. Common oxidizing titrants include KMnO4, cerium(IV), and K2Cr2O7. The choice of oxidizing titrants depends on factors like stability, cost, analyte strength, and reaction rate between the analyte and titrant. KMnO4 is a strong oxidizing titrant that reduces from Mn(VII) to Mn(II) in a highly acidic solution, simultaneously oxidizing the analyte to a higher oxidation state. In this case, KMnO4 acts as a...
Electrical Transport01:29

Electrical Transport

The electrical transport property of a material is defined by its resistance and conductivity. Resistance is the measure of a material's ability to resist the flow of electric current, while conductivity gauges its ability to allow the current to pass through, depending on the geometry of the measurement cell, such as electrode spacing and area. Conductivity is measured in Siemens (S). There are different types of conductance, including specific conductance, equivalent conductance, and molar...
Alkali Metals03:06

Alkali Metals

Group 1 elements are soft and shiny metallic solids. They are malleable, ductile, and good conductors of heat and electricity. The melting points of the alkali metals are unusually low for metals and decrease going down the group, while the density increases going down the group with the exception of potassium (Table 1).
Table 1: Properties of the alkali metals
Potentiometry: Overview01:06

Potentiometry: Overview

Potentiometry is an analytical technique that measures the potential difference between two electrodes in an electrochemical cell without drawing any significant current that could alter the solution's composition. This method employs an indicator electrode, which exchanges electrons with the analyte solution, and a reference electrode with a constant potential. Each electrode is immersed in a solution comprised of two half-cells. In a conventional setup, the reference electrode serves as the...