Related Experiment Video
Updated: May 12, 2026
Fabricating Highly Open Porous Microspheres (HOPMs) via Microfluidic Technology
Published on: May 16, 2022
Preparation of polycaprolactone microspheres-aggregated scaffold with ultra big pores and fuzzy sphere surface by a
1MOE Key Laboratory of Macromolecular Synthesis and Functionalization, Department of Polymer Science and Engineering, Zhejiang University, Hangzhou 310027, China.
Abstract:
A microspheres-aggregated scaffold with ultra big pores (over 300 μm) and fuzzy microspheres is fabricated by incubating polycaprolactone (PCL)/tetrahydrofuran (THF) solution in a -20°C refrigerator, following by freeze-drying. Formation of the scaffold is mainly governed by the crystallization of the PCL polymer at appropriate conditions. All the 10-20% PCL/THF solutions yield the microspheres-aggregated scaffolds when the initial solution temperature is higher than 37°C, whereas the 10-15% solutions form dense membranes when the initial solution temperature is below 25°C. The size of the microspheres and pores is as large as 70-150 μm and 170-816 μm, respectively. The PCL microspheres-aggregated scaffold can better support the adhesion and proliferation of bone marrow mesenchymal stem cells (BMSCs) compared to the traditional porous scaffold obtained by a porogen leaching method. The tendencies of chondrogenesis and osteogenesis differentiation of BMSCs are observed on the microspheres-aggregated scaffold and the ordinary porous scaffold, respectively.
