Related Experiment Video

Updated: May 12, 2026

Experimental System of Solar Adsorption Refrigeration with Concentrated Collector
07:18

Experimental System of Solar Adsorption Refrigeration with Concentrated Collector

Published on: October 18, 2017

Development of polyhouse type solar dryer for Kashmir valley

Navin Chandra Shahi1, Junaid N Khan, Umesh C Lohani

  • 1Department of Post-harvest Process and Food Engineering, G B Pant University of Agriculture and Technology, Pantnagar, 263 145 India.

Journal of Food Science and Technology
|April 11, 2013
PubMed

Keywords:
Full load testingNo load testingPay back periodSolar dryerSolar drying

More Related Videos

Developing Photosensitizer-Cobaloxime Hybrids for Solar-Driven H2 Production in Aqueous Aerobic Conditions10:21

Developing Photosensitizer-Cobaloxime Hybrids for Solar-Driven H2 Production in Aqueous Aerobic Conditions

Published on: October 5, 2019

Construction of a Low-cost Mobile Incubator for Field and Laboratory Use07:50

Construction of a Low-cost Mobile Incubator for Field and Laboratory Use

Published on: March 19, 2019

Related Concept Videos

Drying Shrinkage01:21

Drying Shrinkage

When hardened concrete is exposed to air with a relative humidity of less than 100 percent, it begins to lose the free water within its capillaries. As this water evaporates, the water initially adsorbed onto the calcium silicate hydrates migrates towards these now empty spaces and eventually evaporates as well. Over time, as more water leaves, the volume of the concrete decreases, a phenomenon known as drying shrinkage.
A portion of this drying shrinkage can be reversed; if the concrete is...
P-N junction01:11

P-N junction

A p-n junction is formed when p-type and n-type semiconductor materials are joined together. At the interface of the p-n junction, holes from the p-side and electrons from the n-side begin to diffuse into the opposite sides due to the concentration gradient. This diffusion of carriers leads to a region around the junction where there are no free charge carriers, known as the depletion region. The charge density within the depletion region for the n-side and p-side can be described by the...
Masonry in Cold and Hot Weather Conditions01:21

Masonry in Cold and Hot Weather Conditions

In cold weather, masonry construction requires specific precautions to ensure mortar does not freeze before curing, as this can significantly weaken its strength and watertightness. Mortar temperature should be maintained between 60°F and 80°F to support proper hydration and curing. Below 40°F, mortar water must be heated, but should not exceed 120°F as high temperatures can reduce mortar's compressive and bond strength.
Other key practices include keeping masonry units and sand dry and...
Production of Biopesticides01:18

Production of Biopesticides

Biopesticides offer a sustainable alternative to chemical pesticides, utilizing microbial agents to control agricultural pests. Bacillus thuringiensis (Bt) is a widely employed bacterium known for its potent insecticidal activity. Bt biopesticides are favored for their specificity to insect pests, minimal environmental impact, and natural degradability.Mechanism of Bt Toxin Action Bt produces insecticidal crystal (Cry) proteins during its sporulation phase. These proteins form parasporal...
Responses to Drought and Flooding02:41

Responses to Drought and Flooding

Water plays a significant role in the life cycle of plants. However, insufficient or excess of water can be detrimental and pose a serious threat to plants.
Cavity Drainage and Flashings in Masonry walls01:20

Cavity Drainage and Flashings in Masonry walls

Typically, a cavity wall consists of two wythes separated by a gap of at least 2 inches, which may contain insulation while still maintaining a minimum clear space of 1 inch to facilitate adequate drainage. Advanced methods like the insertion of a continuous drainage mat can further reduce this space while ensuring effective moisture expulsion.
Weep holes, strategically placed at the base of the cavity, are critical for draining accumulated water. These openings are created by leaving head...