Related Experiment Video
Updated: May 11, 2026

A Rapid Method for Modeling a Variable Cycle Engine
Published on: August 13, 2019
Robustness of TCA cycle at steady-state: an LMI-based analysis and synthesis framework
Surajit Panja1, Sourav Patra, Anirban Mukherjee
1Department of Electrical Engineering, Indian Institute of Technology, 721302 Kharagpur, WB, India.
Abstract:
A novel analysis and synthesis framework is devised for synergism and saturation system, commonly known as S-system, for improving the robustness of the TCA cycle. In order to minimize the perturbation sensitivity, a measure of robustness of the network, a new design framework is proposed. The design constraints are formulated in computationally attractive convex optimization framework. The proposed multi-objective optimization problem, framed as Linear Matrix Inequality (LMI), makes a trade-off between the robustness and the control effort of the synthesized TCA cycle.
Related Concept Videos
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be calculated...
Stability
The stability of an LTI system is determined by the roots of its characteristic equation, known as poles. A system is stable if it produces a bounded...
Transient and Steady-state Response
These test signals are integral in designing control systems to exhibit two key performance aspects: transient response and steady-state response.
Cyclic Processes And Isolated Systems
In the case of a non-isolated system, the change in the internal energy is zero only if the process is cyclic. A thermodynamic process is considered cyclic if the system undergoes a series of changes and returns to its initial state.
Consider a cyclic process that returns to its initial state, undergoing a four-step process. The heat transfer along each path...
Respiration Pathways
Multimachine Stability
In analyzing the system, the nodal equations represent the relationship between bus voltages, machine voltages, and machine currents. The nodal equation is given by:
