Related Experiment Video
Updated: May 11, 2026

Simulation, Fabrication and Characterization of THz Metamaterial Absorbers
Published on: December 27, 2012
Transformation optics for antennas: why limit the bandwidth with metamaterials?
Oscar Quevedo-Teruel1, Wenxuan Tang, Rhiannon C Mitchell-Thomas
1School of Electronic Engineering and Computer Science, Queen Mary University of London, London, United Kingdom.
Abstract:
In the last decade, a technique termed transformation optics has been developed for the design of novel electromagnetic devices. This method defines the exact modification of magnetic and dielectric constants required, so that the electromagnetic behaviour remains invariant after a transformation to a new coordinate system. Despite the apparently infinite possibilities that this mathematical tool introduces, one restriction has repeatedly recurred since its conception: limited frequency bands of operation. Here we circumvent this problem with the proposal of a full dielectric implementation of a transformed planar hyperbolic lens which retains the same focusing properties of an original curved lens. The redesigned lens demonstrates operation with high directivity and low side lobe levels for an ultra-wide band of frequencies, spanning over three octaves. The methodology proposed in this paper can be applied to revolutionise the design of many electromagnetic devices overcoming bandwidth limitations.
Related Concept Videos
Mesh Analysis for AC Circuits
The process of harmonizing these impedances begins with a clear understanding of the input and output signals. Once these signals are known, the...
The Antenna Complex
Properties of Fourier Transform I
In radio broadcasting, multiple audio signals often need to be transmitted simultaneously. The Fourier...
The Maximum Power Transfer Theorem
The load connected draws the current, and the circuit delivers the power to the load. The alternating current flowing through the load is determined using the rectangular form of voltages, currents, network impedance, and load impedance. The average power delivered to the load is obtained from the product of the square of current and load resistance.
Properties of the z-Transform I
Cascaded Op Amps
In a cascaded system, each op-amp is referred to as a stage. The output of one stage drives the input of the subsequent stage. As the input signal passes through...

