Related Experiment Video
Updated: May 10, 2026

Assembly of Cell Mimicking Supported and Suspended Lipid Bilayer Models for the Study of Molecular Interactions
Published on: August 3, 2021
Effect of water on interfacial chemical properties of nonionic surfactants in hydrophobic ionic liquid bmimPF6
Takeshi Misono1, Kenichi Aburai, Takeshi Endo
1Department of Pure and Applied Chemistry, Faculty of Science and Technology, Tokyo University of Science, Yamazaki, Noda, Chiba, Japan.
Abstract:
We studied the effect of water addition on interfacial properties and aggregate behavior of nonionic surfactants (polyoxyethylene alkyl ether; CnEm) in an ionic liquid (1-butyl-3-methylimidazolium hexafluorophosphate; bmimPF₆). When a small amount of water was added to mixtures of CnEm and bmimPF₆, two breaking points (cac1, cac2) were observed in the surface tension/CnEm concentration plots, suggesting the formation of two kinds of aggregates. This two-step aggregate formation was also confirmed by the fluorescence probe method using pyrene. The particle size of the aggregates measured by dynamic light scattering (DLS) was around 200 nm at cac1, and decreased to 4 nm above cac2. These results, together with freeze-fracture TEM observations, showed that the aggregate formed at cac1 was water in bmimPF₆ emulsions, which then transformed to micelles solubilizing water in the palisade layer above cac2. This concentration-dependent aggregate formation was supported thermodynamically by studying the dependence of cacs on temperature and alkyl and POE chain lengths of the surfactant.
Related Concept Videos
Surface Active Agents
Micelles
Intermolecular Forces and Physical Properties
Intermolecular Forces
Comparing Intermolecular Forces: Melting Point, Boiling Point, and Miscibility
Temporary attractive forces like dispersion are present in all molecules, whether they are polar or nonpolar. They...
Solubility
A solution is a homogeneous mixture composed of a solvent, the major component, and a solute, the minor component. The physical state of a solution—solid, liquid, or gas—is typically the same as that of the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
In a solution, the solute particles (molecules, atoms, and/or ions)...

