Estimation of sex from index and ring finger in a North Indian population
Kewal Krishan1, Tanuj Kanchan, Ningthoukhongjam Asha
1Department of Anthropology, Panjab University, Chandigarh, India. gargkk@yahoo.com
Abstract:
Estimation of sex is an important parameter in the examination of unknown dismembered and commingled remains. The present study explores the possibility of estimation of sex from length of index and ring finger and the index and ring finger ratio in 140 individuals (70 boys and 70 girls) from North India. Index finger length (IFL) and ring finger length (RFL) of the participants were measured following standard procedures and landmarks. Sex differentiation in the present study was based on sectioning point analysis. The 'sectioning point' for the IFL, RFL and the index and the ring finger ratio was estimated from the average of the mean of male and female values. Binary logistic regression (BLR) analysis was employed to derive a predicting equation for estimation of sex. The results of the present study indicate that significant sex differences exist in the IFL and RFL and index and ring finger ratio. Among finger lengths, RFL is a better predictor of sex than IFL. It is further concluded that the index and ring finger length is of limited utility in estimation of sex in forensic casework and should be employed only in cases when no other means of sexing are available. The study suggests that the index and ring finger ratio should not be employed in estimation of sex in forensic casework due to considerable overlap in male and female values.
Related Concept Videos
The Ratio of X Chromosome to Autosomes
Normal male Drosophila has a ratio of one X chromosome to two sets of autosomes. In contrast, normal female Drosophila...
Assessment of apical radial pulse
The A-R pulse assessment involves simultaneous evaluation of the apical and radial pulses. When the apical and radial pulse rates vary, this assessment helps identify a pulse deficit.
Pre-Procedural Preparation
Assessment of radial pulse
The radial pulse, located at the wrist, is often the preferred site for assessing peripheral pulse because of its accessibility and dependability. The process of determining the radial pulse involves several steps:
Assessment of blood pressure in brachial artery(one-step method)
Prepare for the Procedure:
Assessment of blood pressure in brachial artery(two-step method)
Testing a Claim about Mean: Unknown Population SD
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used; instead...

