Jove
Visualize
Contact Us
JoVE
x logofacebook logolinkedin logoyoutube logo
ABOUT JoVE
OverviewLeadershipBlogJoVE Help Center
AUTHORS
Publishing ProcessEditorial BoardScope & PoliciesPeer ReviewFAQSubmit
LIBRARIANS
TestimonialsSubscriptionsAccessResourcesLibrary Advisory BoardFAQ
RESEARCH
JoVE JournalMethods CollectionsJoVE Encyclopedia of ExperimentsArchive
EDUCATION
JoVE CoreJoVE BusinessJoVE Science EducationJoVE Lab ManualFaculty Resource CenterFaculty Site
Terms & Conditions of Use
Privacy Policy
Policies

Related Concept Videos

Interval Level of Measurement00:55

Interval Level of Measurement

For effective statistical analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
Data measured using the interval scale are similar to ordinal level data because they have a definite arrangement. However, in the interval level of measurement, the differences between data values are meaningful even though the data does not have a starting point.
Temperature is measured using the interval scale. It is measurable data, and the difference between the...
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
Introduction to Limits01:30

Introduction to Limits

A limit describes the value a function approaches as its input moves closer to a particular point. Even when a function is undefined at a specific value, limits allow us to analyze its behavior near that point. This concept is fundamental in calculus and essential for understanding continuity, derivatives, and integrals.Mathematically, a function f(x) has a limit L at x = a if its values L approach x as x gets arbitrarily close to a. This is written as:This notation expresses that the function...
Decreasing Function01:27

Decreasing Function

A decreasing function describes a relationship where the output consistently declines as the input increases. This means that for any two input values, if one is greater than the other, the corresponding output is smaller. Mathematically, a function f is decreasing on an interval I if for every x1 < x2​ in I, f (x1) > f (x2). This type of behavior is visually identified on a graph that slopes downward from left to right.The nature of a function can be analyzed by calculating its rate of...
Freezing Point Depression and Boiling Point Elevation03:12

Freezing Point Depression and Boiling Point Elevation

Boiling Point Elevation
The boiling point of a liquid is the temperature at which its vapor pressure is equal to ambient atmospheric pressure. Since the vapor pressure of a solution is lowered due to the presence of nonvolatile solutes, it stands to reason that the solution’s boiling point will subsequently be increased. Vapor pressure increases with temperature, and so a solution will require a higher temperature than will pure solvent to achieve any given vapor pressure, including one...
Downsampling01:20

Downsampling

When considering a sampled sequence with zero values between sampling instants, one can replace it by taking every N-th value of the sequence. At these integer multiples of N, the original and sampled sequences coincide. This process, known as decimation, involves extracting every N-th sample from a sequence, thereby creating a more efficient sequence.
The Fourier transform of the decimated sequence reveals a combination of scaled and shifted versions of the original spectrum. This...

You might also read

Related Articles

Articles linked to this work by shared authors, journal, and citation graph.

Sort by
Same author

In a nutshell: Pandora's Box-B-cell lymphoproliferation masking inborn errors of immunity.

British journal of haematology·2026
Same author

Thrombopoietin agents and marrow fibrosis: fact or myth.

Haematologica·2026
Same author

Fetal and neonatal alloimmune thrombocytopenia (FNAIT): Survey of UK fetal medicine centres on antenatal management of subsequent affected pregnancies.

British journal of haematology·2026
Same author

Chimeric antigen receptor T cells for autoimmune diseases, in particular immune thrombocytopenia.

British journal of haematology·2026
Same author

Efficacy and Safety of Subcutaneous Efgartigimod PH20 in Adults With Primary Immune Thrombocytopenia (ADVANCE SC): A Multicenter, Randomized, Double-Blinded, Placebo-Controlled, Phase 3 Trial.

American journal of hematology·2026
Same author

A multicentre analysis of efficacy, safety and molecular response correlates of fostamatinib in warm autoimmune haemolytic anaemia and Evans syndrome.

British journal of haematology·2026
Same journal

Fibrocytes drive JAK2V617F-mutated myelofibrosis: pitavastatin reverses marrow fibrosis and anemia.

Blood·2026
Same journal

Identifying steroid-refractory aGVHD before it happens.

Blood·2026
Same journal

ELISA-negative HIT: antibody recognition and relevance.

Blood·2026
Same journal

EBV and immunodeficiency: the odd couple drawn to the brain.

Blood·2026
Same journal

A bone to pick with ferric carboxymaltose.

Blood·2026
Same journal

A step toward streamlining HIT diagnosis.

Blood·2026
See all related articles

Related Experiment Video

Updated: May 10, 2026

Reduced-gravity Environment Hardware Demonstrations of a Prototype Miniaturized Flow Cytometer and Companion Microfluidic Mixing Technology
13:59

Reduced-gravity Environment Hardware Demonstrations of a Prototype Miniaturized Flow Cytometer and Companion Microfluidic Mixing Technology

Published on: November 13, 2014

How low can you go?

W Beau Mitchell1, James B Bussel

  • 1Weill Cornell Medical College.

Blood
|June 15, 2013
PubMed
Summary
This summary is machine-generated.

This study identifies the minimum platelet count required for blood clot formation in a mouse model. Understanding this threshold is crucial for managing bleeding disorders and thrombosis risks.

More Related Videos

Tilt Testing with Combined Lower Body Negative Pressure: a "Gold Standard" for Measuring Orthostatic Tolerance
14:09

Tilt Testing with Combined Lower Body Negative Pressure: a "Gold Standard" for Measuring Orthostatic Tolerance

Published on: March 21, 2013

Low-Cost, Volume-Controlled Dipstick Urinalysis for Home-Testing
06:55

Low-Cost, Volume-Controlled Dipstick Urinalysis for Home-Testing

Published on: May 8, 2021

Related Experiment Videos

Last Updated: May 10, 2026

Reduced-gravity Environment Hardware Demonstrations of a Prototype Miniaturized Flow Cytometer and Companion Microfluidic Mixing Technology
13:59

Reduced-gravity Environment Hardware Demonstrations of a Prototype Miniaturized Flow Cytometer and Companion Microfluidic Mixing Technology

Published on: November 13, 2014

Tilt Testing with Combined Lower Body Negative Pressure: a "Gold Standard" for Measuring Orthostatic Tolerance
14:09

Tilt Testing with Combined Lower Body Negative Pressure: a "Gold Standard" for Measuring Orthostatic Tolerance

Published on: March 21, 2013

Low-Cost, Volume-Controlled Dipstick Urinalysis for Home-Testing
06:55

Low-Cost, Volume-Controlled Dipstick Urinalysis for Home-Testing

Published on: May 8, 2021

Area of Science:

  • Hematology
  • Hemostasis and Thrombosis

Background:

  • Thrombocytopenia, a condition of low platelet count, poses significant risks for both bleeding and clotting.
  • Platelets play a critical role in hemostasis and thrombosis.

Purpose of the Study:

  • To determine the lowest effective platelet count necessary to support thrombus formation under various thrombotic conditions.
  • To establish a quantitative relationship between platelet count and thrombosis support.

Main Methods:

  • Utilized a mouse model engineered to exhibit varying degrees of thrombocytopenia.
  • Subjected the model to a spectrum of thrombosis challenges to assess clot formation.
  • Quantified platelet counts and thrombus development.

Main Results:

  • Identified a specific minimum platelet count threshold essential for initiating and sustaining thrombosis.
  • Demonstrated that below this threshold, thrombus formation is significantly impaired.
  • Observed variations in the required platelet count depending on the nature of the thrombotic stimulus.

Conclusions:

  • The study establishes a critical lower limit for platelet count to ensure adequate thrombosis.
  • Findings provide valuable insights into the quantitative role of platelets in hemostasis and thrombosis.
  • This research has implications for understanding bleeding risks in thrombocytopenic patients.