Related Experiment Video
Updated: May 10, 2026

Low-cost Custom Fabrication and Mode-locked Operation of an All-normal-dispersion Femtosecond Fiber Laser for Multiphoton Microscopy
Published on: November 22, 2019
High-power mid-infrared frequency comb source based on a femtosecond Er:fiber oscillator
Feng Zhu1, Holger Hundertmark, Alexandre A Kolomenskii
1Department of Physics and Astronomy, Texas A&M University, College Station, Texas 77843-4242, USA. zhuf@physics.tamu.edu
Abstract:
We report on a high-power mid-infrared (MIR) frequency comb source based on a femtosecond (fs) Er:fiber oscillator with a stabilized repetition rate of 250 MHz. The MIR frequency comb is produced through difference frequency generation in a periodically poled MgO-doped lithium niobate crystal. The output power is about 120 mW, with a pulse duration of about 80 fs and spectrum coverage from 2.9 to 3.6 μm, and the single comb mode power is larger than 0.3 μW over the range of 700 nm. The coherence properties of the produced high-power broadband MIR frequency comb are maintained, which was verified by heterodyne measurements. As the first application, the spectrum of a ~200 ppm methane-air mixture in a short 20 cm glass cell at ambient atmospheric pressure and temperature was measured.

