Related Experiment Video

Updated: May 9, 2026

Experimental Investigation of Secondary Flow Structures Downstream of a Model Type IV Stent Failure in a 180° Curved Artery Test Section
11:00

Experimental Investigation of Secondary Flow Structures Downstream of a Model Type IV Stent Failure in a 180° Curved Artery Test Section

Published on: July 19, 2016

Numerical verification of the random-phase-and-amplitude formalism of weak turbulence

Mitsuhiro Tanaka1, Naoto Yokoyama

  • 1Faculty of Engineering, Gifu University, Gifu 501-1193, Japan. tanaka@gifu-u.ac.jp

Physical Review. E, Statistical, Nonlinear, and Soft Matter Physics
|July 16, 2013
PubMed

More Related Videos

Visually Based Characterization of the Incipient Particle Motion in Regular Substrates: From Laminar to Turbulent Conditions11:51

Visually Based Characterization of the Incipient Particle Motion in Regular Substrates: From Laminar to Turbulent Conditions

Published on: February 22, 2018

Simultaneous Measurement of Turbulence and Particle Kinematics Using Flow Imaging Techniques10:53

Simultaneous Measurement of Turbulence and Particle Kinematics Using Flow Imaging Techniques

Published on: March 12, 2019

Related Concept Videos

Wald-Wolfowitz Runs Test II01:17

Wald-Wolfowitz Runs Test II

The Wald-Wolfowitz runs test, commonly referred to as the runs test, is a nonparametric test used to assess the randomness of ordered data. The test evaluates the number of runs, which are consecutive sequences of similar elements within the data. If the number of runs is significantly higher or lower than expected, the data is considered non-random, indicating a detectable pattern or structure.
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and 0s. In...
The Phase Rule01:20

The Phase Rule

The phase rule describes the relationship between the variance (degrees of freedom), the number of components, and the number of phases in a system at equilibrium.Variance is a concept that denotes the number of independent intensive properties (properties are those that do not depend on the amount of material in the system), such as temperature, pressure, and composition, that can be altered without impacting the number of phases in equilibrium.In a single-component system, such as pure water,...
Propagation of Uncertainty from Random Error00:59

Propagation of Uncertainty from Random Error

An experiment often consists of more than a single step. In this case, measurements at each step give rise to uncertainty. Because the measurements occur in successive steps, the uncertainty in one step necessarily contributes to that in the subsequent step. As we perform statistical analysis on these types of experiments, we must learn to account for the propagation of uncertainty from one step to the next. The propagation of uncertainty depends on the type of arithmetic operation performed on...
Propagation of Uncertainty from Systematic Error01:10

Propagation of Uncertainty from Systematic Error

The atomic mass of an element varies due to the relative ratio of its isotopes. A sample's relative proportion of oxygen isotopes influences its average atomic mass. For instance, if we were to measure the atomic mass of oxygen from a sample, the mass would be a weighted average of the isotopic masses of oxygen in that sample. Since a single sample is not likely to perfectly reflect the true atomic mass of oxygen for all the molecules of oxygen on Earth, the mass we obtain from this particular...
The Buckingham Pi Theorem01:09

The Buckingham Pi Theorem

The Buckingham Pi theorem provides a structured method to simplify fluid dynamics problems by reducing complex systems of variables to dimensionless terms.
Dimensionless Groups in Fluid Mechanics01:15

Dimensionless Groups in Fluid Mechanics

Dimensionless groups in fluid mechanics provide simplified ratios that help analyze fluid behavior without relying on specific units. The Reynolds number (Re), which represents the ratio of inertial to viscous forces, distinguishes between laminar and turbulent flows, making it essential in the design of pipelines and aerodynamic surfaces. The Froude number (Fr), the ratio of inertial to gravitational forces, is particularly useful in predicting wave formation and hydraulic jumps in...