Related Experiment Video

Updated: May 9, 2026

A Protocol for Conducting Rainfall Simulation to Study Soil Runoff
10:35

A Protocol for Conducting Rainfall Simulation to Study Soil Runoff

Published on: April 3, 2014

Effect of rain gauge density over the accuracy of rainfall: a case study over Bangalore, India

Anoop Kumar Mishra1

  • 1Research Centre for Environmental Changes, Academia Sinica, 128 Academia Road, Section 2, Nankang, Taipei, Taiwan ROC 11529.

Springerplus
|July 27, 2013
PubMed

Keywords:
HydrologyPrecipitationRain gaugeRemote sensingSatellite

More Related Videos

BtM, a Low-cost Open-source Datalogger to Estimate the Water Content of Nonvascular Cryptogams08:25

BtM, a Low-cost Open-source Datalogger to Estimate the Water Content of Nonvascular Cryptogams

Published on: March 25, 2019

Façade-Level Monitoring of CO2 Variability under Urban Heat Island Conditions using Low-Cost Sensor Data Loggers07:12

Façade-Level Monitoring of CO2 Variability under Urban Heat Island Conditions using Low-Cost Sensor Data Loggers

Published on: December 12, 2025

Related Concept Videos

Random Error01:04

Random Error

Random or indeterminate errors originate from various uncontrollable variables, such as variations in environmental conditions, instrument imperfections, or the inherent variability of the phenomena being measured. Usually, these errors cannot be predicted, estimated, or characterized because their direction and magnitude often vary in magnitude and direction even during consecutive measurements. As a result, they are difficult to eliminate. However, the aggregate effect of these errors can be...
Precipitation Gravimetry01:03

Precipitation Gravimetry

Precipitation gravimetry is based on converting an analyte into a sparingly soluble precipitate, which is separated by filtration and weighed. An ideal precipitate should be pure, insoluble, of known composition, and easily filtered from the reaction mixture.
In determining nickel by gravimetric analysis, a precipitant of ethanolic dimethylglyoxime is added to a hot nickel salt solution. This is quickly followed by the dropwise addition of dilute ammonia solution until precipitation occurs. A...
Precipitation Titration Curve: Analysis01:21

Precipitation Titration Curve: Analysis

The precipitation titration curve demonstrates the change in concentration of one reactant with the volume of titrant added. During the titration of chloride ions with silver nitrate, the precipitation titration curve is divided into three regions: before, at, and after the equivalence point. Before the equivalence point, low redissolution of the sparingly soluble silver chloride precipitate gives a low silver ion concentration. However, in the second region, representing the equivalence point,...
Density00:56

Density

Density is an important characteristic of substances, crucial in determining whether an object sinks or floats in a fluid. Its SI unit is kg/m3, and its cgs unit is g/cm3. The density of an object helps in identifying its composition, and also reveals information about the phase of the matter and its substructure. The densities of liquids and solids are roughly comparable, consistent with the fact that their atoms are in close contact. However, gases have much lower densities than liquids and...
Precipitation and Co-precipitation01:17

Precipitation and Co-precipitation

Precipitation and coprecipitation methods can be used to separate a mixture of ions in a solution. In qualitative inorganic analysis, ions that form sparingly soluble precipitates with the same reagent are separated based on the differences in solubility products. For example, consider the separation of Cu(II) and Fe(II) ions by precipitation as insoluble sulfides. First, copper(II) sulfide is precipitated by the addition of acidic H2S, where the dissociation of H2S is suppressed. Adding H2S...
Density, Specific Weight, Specific Gravity and Compressibility of Fluid01:27

Density, Specific Weight, Specific Gravity and Compressibility of Fluid

Density, specific weight, specific gravity, and compressibility are fundamental properties of fluids. Density is the mass per unit volume, characterizing the mass of a fluid system. It influences buoyancy, pressure, flow dynamics, viscosity, thermal conductivity, and sound propagation. For instance, in pipeline design, accurate density measurements ensure that the pipeline can handle the fluid's mass.
Specific weight represents the weight per unit volume and is calculated by multiplying density...