Related Experiment Video
Updated: May 9, 2026

Establishment and Evaluation of a Sheep Model of Full-thickness Osteochondral Defect
Published on: April 14, 2026
Complex nature of stress inside loaded articular cartilage
1Biomechanics Laboratory, Department of Mechanical Engineering, University of Auckland, Auckland, New Zealand.
Abstract:
We show that in the early stages of loading of the cartilage matrix extensive water exudation and related physicochemical and structural changes give rise to a distinctly consolidatable system. By enzymatically modifying the pre-existing osmotic condition of the normal matrix and measuring its hydrostatic excess pore pressure, we have studied the exact influence of physicochemistry on the consolidation of cartilage. We argue that the attainment of a certain minimum level of swelling stiffness of the solid skeleton, which is developed at the maximum hydrostatic excess pore pressure of the fluid, controls the effective consolidation of articular cartilage. Three related but distinct stresses are developed during cartilage deformation, namely (1) the swelling stress in the coupled proteoglycan/collagen skeleton in the early stages of deformation, (2) the hydrostatic excess pore pressure carried by the fluid component, and (3) the effective stress generated on top of the minimum value of the swelling stress in the consolidation stages following the attainment of the fluid's maximum pore pressure. The minimum value of the swelling pressure is in turn generated over and above the intrinsic osmotic pressure in the unloaded matrix. The response of the hyaluronidase-digested matrix relative to its intact state again highlights the important influence of the osmotic pressure and the coefficient of permeability, both of which are related to the volume fraction of proteoglycans on cartilage deformation, and therefore its ability to function as an effective stress-redistributing layer above the subchondral bone.
More Related Videos
Related Concept Videos
Stress: General Loading Conditions
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes.
Components of Stress
Interestingly, the hidden cube faces also experience these stresses, equal and opposite to those on the...
Structural Joints: Synovial Joints
Knee Joint
A total of seven ligaments support the knee joint. The patellar ligament, which is also attached to the quadriceps femoris group...
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Growth of Cartilage and Bone Tissue

