On the costs of lag-1 sparing

Paul E Dux1, Brad Wyble2, Pierre Jolicœur3

  • 1School of Psychology, University of Queensland.

Related Concept Videos

Time and frequency -Domain Interpretation of Phase-lag Control01:21

Time and frequency -Domain Interpretation of Phase-lag Control

Phase-lag controllers are widely used in control systems to improve stability and reduce steady-state errors. A dimmer switch controlling the brightness of a light bulb serves as a practical example of phase-lag control, gradually adjusting the bulb's brightness. Mathematically, phase-lag control or low-pass filtering is represented when the factor 'a' is less than 1.
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any finite,...
Lagging Strand Synthesis01:59

Lagging Strand Synthesis

During replication, the complementary strands in double-stranded DNA are synthesized at different rates. Replication first begins on the leading strand. Replication starts later, occurs more slowly, and proceeds discontinuously on the lagging strand.
There are several major differences between synthesis of the leading strand and synthesis of the lagging strand. 1) Leading strand synthesis happens in the direction of replication fork opening, whereas lagging strand synthesis happens in the...
Lagging Strand Synthesis01:59

Lagging Strand Synthesis

During replication, the complementary strands in double-stranded DNA are synthesized at different rates. Replication first begins on the leading strand. Replication starts later, occurs more slowly, and proceeds discontinuously on the lagging strand.
There are several major differences between synthesis of the leading strand and synthesis of the lagging strand. 1) Leading strand synthesis happens in the direction of replication fork opening, whereas lagging strand synthesis happens in the...
Calculation of First-Law Quantities II01:24

Calculation of First-Law Quantities II

The first law of thermodynamics establishes that the change in internal energy of a system is given by ΔU = q + w, where q is the heat exchanged, and w is the work performed. For a perfect gas, both internal energy (U) and enthalpy (H) depend solely on temperature. Consequently, for any change of state, whether reversible or irreversible, the internal energy change is determined by integrating the heat capacity at constant volume, and the enthalpy change by integrating the heat capacity at...
Calculation of First Law Quantities I01:25

Calculation of First Law Quantities I

Thermodynamic systems undergoing phase transitions or temperature changes experience energy transfer in the form of heat (q) and work (w). For a reversible phase change at constant temperature (T) and pressure (p), the process involves no chemical reaction but results in energy exchange between distinct phases.The heat transferred during this process corresponds to the latent heat of transition, which is the amount of heat energy absorbed or released by a substance when it changes from one...
Reducing Line Loss01:18

Reducing Line Loss

In a three-phase circuit, line loss is an indicator of energy dissipated as heat due to the resistance of transmission lines. To address this, incorporating transformers into the system—a step-up transformer at the source and a step-down transformer at the load—is a strategic solution. Two three-phase transformers are introduced to improve this.
With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss in...