Related Experiment Video

Updated: May 8, 2026

Hyperspectral Imaging as a Tool to Study Optical Anisotropy in Lanthanide-Based Molecular Single Crystals
07:24

Hyperspectral Imaging as a Tool to Study Optical Anisotropy in Lanthanide-Based Molecular Single Crystals

Published on: April 14, 2020

Nonradiative energy transfer between two different activator sites in La(4-x)Ca(x)Si12O(3+x)N(18-x):Eu2+

Woon Bae Park1, Youngjun Song, Myoungho Pyo

  • 1Faculty of Nanotechnology and Advanced Materials Engineering, Sejong University, Seoul, South Korea.

Optics Letters
|August 14, 2013
PubMed

More Related Videos

Quantitative Atomic-Site Analysis of Functional Dopants/Point Defects in Crystalline Materials by Electron-Channeling-Enhanced Microanalysis07:24

Quantitative Atomic-Site Analysis of Functional Dopants/Point Defects in Crystalline Materials by Electron-Channeling-Enhanced Microanalysis

Published on: May 10, 2021

Low-energy Cathodoluminescence for (Oxy)Nitride Phosphors07:03

Low-energy Cathodoluminescence for (Oxy)Nitride Phosphors

Published on: November 15, 2016

Related Concept Videos

Deactivation Processes: Jablonski Diagram01:25

Deactivation Processes: Jablonski Diagram

Luminescence, the emission of light by a substance that has absorbed energy, is a process that involves the interaction of molecules with light. The energy-level diagram, or Jablonski diagram, is a graphical representation of these interactions, illustrating the various states and transitions a molecule can undergo. In a typical Jablonski diagram, the lowest horizontal line represents the ground-state energy of the molecule, which is usually a singlet state. This state represents the energies...
Photochemical Electrocyclic Reactions: Stereochemistry01:26

Photochemical Electrocyclic Reactions: Stereochemistry

The absorption of UV–visible light by conjugated systems causes the promotion of an electron from the ground state to the excited state. Consequently, photochemical electrocyclic reactions proceed via the excited-state HOMO rather than the ground-state HOMO. Since the ground- and excited-state HOMOs have different symmetries, the stereochemical outcome of electrocyclic reactions depends on the mode of activation; i.e., thermal or photochemical.
Selection Rules: Photochemical Activation
Activation Energy01:26

Activation Energy

Activation energy is the minimum amount of energy necessary for a chemical reaction to move forward. The higher the activation energy, the slower the rate of the reaction. However, adding heat to the reaction will increase the rate, since it causes molecules to move faster and increase the likelihood that molecules will collide. The collision and breaking of bonds represents the uphill phase of a reaction and generates the transition state. The transition state is an unstable high-energy state...
Cycloaddition Reactions: MO Requirements for Photochemical Activation01:12

Cycloaddition Reactions: MO Requirements for Photochemical Activation

Some cycloaddition reactions are activated by heat, while others are initiated by light. For example, a [2 + 2] cycloaddition between two ethylene molecules occurs only in the presence of light. It is photochemically allowed but thermally forbidden.
Cycloaddition Reactions: MO Requirements for Thermal Activation01:16

Cycloaddition Reactions: MO Requirements for Thermal Activation

Thermal cycloadditions are reactions where the source of activation energy needed to initiate the reaction is provided in the form of heat. A typical example of a thermally-allowed cycloaddition is the Diels–Alder reaction, which is a [4 + 2] cycloaddition. In contrast, a [2 + 2] cycloaddition is thermally forbidden.
Enzymes and Activation Energy01:13

Enzymes and Activation Energy

The activation energy (or free energy of activation), abbreviated as Ea, is the small amount of energy input necessary for all chemical reactions to occur. During chemical reactions, certain chemical bonds break, and new ones form. For example, when a glucose molecule breaks down, bonds between the molecule's carbon atoms break. Since these are energy-storing bonds, they release energy when broken. However, the molecule must be somewhat contorted to get into a state that allows the bonds to...