Related Experiment Video
Updated: May 8, 2026

Induction and Evaluation of Inbreeding Crosses Using the Ant, Vollenhovia Emeryi
Published on: October 5, 2018
Estimates of genetic relatedness among males in a polygynous wasp
K Kudô1, S Sugawara, K Shinohara
1Lab of Insect Ecology, Fac of Education, Niigata Univ, Niigata 950-2181, Japan. kudok@ed.niigata-u.ac.jp
Abstract:
Cyclical oligogyny is considered to be the mechanism that is most likely to be responsible for stabilizing cooperation in polygynous, epiponine wasps, in which single-queen colonies produce new queens and multiple-queen colonies produce males. In contrast with the number of studies on relatedness among adult females, we know little about relatedness among males in polygynous epiponine wasps. We estimated worker and male relatedness in the Brazilian epiponine wasp Polybia paulista Ihering and found that colonies of P. paulista produced males when they contained multiple queens. Although average relatedness within males did not differ significantly from 0.5, the number of alleles observed suggests that there were more than one queen to produce males in each colony. Our data would be helpful to elucidate dynamics of the male production in a colony of epiponine wasps.
Related Concept Videos
The Ratio of X Chromosome to Autosomes
Normal male Drosophila has a ratio of one X chromosome to two sets of autosomes. In contrast, normal female Drosophila...
Testing a Claim about Population Proportion
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
Evolutionary Relationships through Genome Comparisons
Inclusive Fitness
Testing a Claim about Mean: Unknown Population SD
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used; instead...
Chi-square Analysis
The chi-square test was developed by Pearson in 1990.
The first step of performing a Chi-square analysis is to establish a null hypothesis, which assumes that there is no real...

