Cooling rate and ice-crystal measurement in biological specimens plunged into liquid ethane, propane, and Freon 22

Specimens sandwiched between copper planchettes were plunged up to a depth of 430 mm into coolants used for cryofixation. Hydrated gelatin containing a miniature thermocouple was used to mimic the behaviour of tissue during freezing. Gelatin and red blood cells were used for ice-crystal analysis. Ethane produced the fastest cooling rates and the smallest ice-crystal profiles, and Freon 22 produced the slowest cooling rates and the largest crystal profiles. Smaller crystal profiles were often seen in the centre of the specimens than in subsurface zones. The results show that ethane, rather than propane, should be used for freezing metal-sandwiched freeze-fracture specimens by the plunging method, and probably also in the jet-cooling method. They further suggest that good cryofixation could occur at the centre of thin specimens rather than only at their surfaces. Comparison between theoretical and experimental ice-crystal sizes was satisfactory, indicating that where the experimental parameters can be defined then realistic predictions can be made regarding cryofixation results.