Related Experiment Video
Updated: May 8, 2026

Practical Considerations for the Design, Execution, and Interpretation of Studies Involving Whole-Bone Bending Tests of Rodent Bones
Published on: September 1, 2023
Mechanical properties of sand tiger shark (Carcharias taurus) vertebrae in relation to spinal deformity
Daniel R Huber1, Danielle E Neveu, Charlotte M Stinson
1Department of Biology, The University of Tampa, Tampa, FL 33606, USA.
Abstract:
Approximately 35% of sand tiger sharks (Carcharias taurus) in public aquaria exhibit spinal deformities ranging from compressed vertebrae and loss of intervertebral space to dislocated spines with vertebral degeneration and massive spondylosis caused by excessive mineralization both within vertebrae and outside the notochordal sheath. To identify the mechanical basis of these deformities, vertebral centra from affected (N=12) and non-affected (N=9) C. taurus were subjected to axial compression tests on an MTS 858 Bionix material testing system, after which mineral content was determined. Vertebral centra from affected sharks had significantly lower mineral content and material behavior in nearly all variables characterizing elasticity, plasticity and failure. These mechanical deficiencies are correlated with size at capture, capture method, vitamin C and zinc deficiency, aquarium size and swimming behavior in public aquaria. Non-affected C. taurus had greater stiffness and toughness even though these properties are generally incompatible in mineralized structures, suggesting that the biphasic (mineralized, unmineralized phases) nature of chondrichthyan vertebrae yields material behavior not otherwise observed in vertebrate skeletons. However, vertebral centra from non-affected sharks had lower mineral content (33%), stiffness (167 MPa), yield strain (14%) and ultimate strength (16 MPa) than other species of sharks and bony vertebrates, indicating that biomechanical precautions must be taken in the husbandry of this species.
Related Concept Videos
Vertebral Column: Regions and Curvature
Regions of the Vertebral Column
In an adult, the spine is subdivided into five regions: the cervical, the thoracic, the lumbar, the sacral, and the coccygeal region. The spine initially develops as a series of 33 vertebrae; after 20 years of age, the nine bones in the sacral region, five sacral, and four coccygeal bones fuse to form the...
General Structure of a Vertebra
Deformation in a Circular Shaft
Structural Joints: Cartilaginous Joints
There are two types of cartilaginous joints:
Synchondrosis
A synchondrosis ("joined by cartilage") is a cartilaginous joint where bones are connected by hyaline cartilage. Synchondrosis may be temporary or...
Torsion of Noncircular Members
Spinal Cord: Gross Anatomy