Marginal discrepancy as affected by selective placement of die-spacer: an in vitro study

An increase in the marginal discrepancy is seen after cementation with a luting agent and provision of cement space with a die-spacer is the most preferred method to avoid it. Recommended thickness of die-spacer is 25-40 μm. Smaller die-spacer thickness was consistently found at the axio-occlusal line angles as compared to the other surfaces which has been postulated to that the spacer paint tends to flow away from the sharp line angles and cusp tips as a result of increased surface tension. The absence of adequate relief spaces in these areas impedes the flow of cement beyond the occlusal portion of the casting, which would result in incomplete seating because of hydraulic pressure. Fifty stone dies were duplicated from a steel die and were divided into five groups of sample size 10, where the die-spacer was selectively placed. Measurements were taken at four points, 90° apart from each other with the help of optical microscope. Later all the castings were cemented using Glass Inomer cement as a luting agent, under a 10 kg static load and measurements were recorded. Statistical analysis showed samples with no spacer had the maximum pre and post cementation gap while the least discrepancy was seen in group with additional layer of die-spacer painted over the axio-occlusal line angle. The results were highly significant which clearly indicated the superiority of this group over others. Within limitations of the study, it can be said that application of additional layer of die-spacer at the axio-occlusal line angle will help in decreasing the post cementation marginal discrepancy in full cast metal crowns.