Related Experiment Video
Updated: May 7, 2026
Microinjection for Transgenesis and Genome Editing in Threespine Sticklebacks
Published on: May 13, 2016
Bringing habitat information into statistical tests of local adaptation in quantitative traits: a case study of
M Karhunen1, O Ovaskainen, G Herczeg
1Department of Biosciences, University of Helsinki, PO Box 65,, FI-00014, Finland. markku.karhunen@helsinki.fi.
Abstract:
Detection of footprints of historical natural selection on quantitative traits in cross-sectional data sets is challenging, especially when the number of populations to be compared is small and the populations are subject to strong random genetic drift. We extend a recent Bayesian multivariate approach to differentiate between selective and neutral causes of population differentiation by the inclusion of habitat information. The extended framework allows one to test for signals of selection in two ways: by comparing the patterns of population differentiation in quantitative traits and in neutral loci, and by comparing the similarity of habitats and phenotypes. We illustrate the framework using data on variation of eight morphological and behavioral traits among four populations of nine-spined sticklebacks (Pungitius pungitius). In spite of the strong signal of genetic drift in the study system (average FST = 0.35 in neutral markers), strong footprints of adaptive population differentiation were uncovered both in morphological and behavioral traits. The results give quantitative support for earlier qualitative assessments, which have attributed the observed differentiation to adaptive divergence in response to differing ecological conditions in pond and marine habitats.
Related Concept Videos
01:06Fixed Action Patterns
01:11Testing a Claim about Mean: Known Population SD
Estimating a population mean requires the samples to be distributed normally. The data should be collected from the randomly selected samples having no sampling bias. The sample size needed to be higher than 30, and most importantly, the population standard deviation should be already known.
In most realistic situations, the population standard deviation is often unknown, but in rare circumstances, when it...
02:16Genetics of Speciation
01:26Derivatives: Problem Solving
02:31Habitat Fragmentation
01:21Testing a Claim about Mean: Unknown Population SD
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used;...