Related Experiment Video

Updated: May 7, 2026

Fabrication and Characterization of High-Q Silicon Nitride Membrane Resonators
09:46

Fabrication and Characterization of High-Q Silicon Nitride Membrane Resonators

Published on: August 8, 2025

1.3K

Quantum-criticality-induced strong Kerr nonlinearities in optomechanical systems

Xin-You Lü1, Wei-Min Zhang, Sahel Ashhab

  • 11] CEMS, RIKEN, Saitama, 351-0198, Japan [2] Wuhan National Laboratory for Optoelectronics and School of Physics, Huazhong University of Science and Technology, Wuhan 430074, People's Republic of China.

Scientific Reports
|October 16, 2013
PubMed

More Related Videos

Spectral and Angle-Resolved Magneto-Optical Characterization of Photonic Nanostructures08:01

Spectral and Angle-Resolved Magneto-Optical Characterization of Photonic Nanostructures

Published on: November 21, 2019

6.6K
Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators09:23

Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators

Published on: May 30, 2014

14.0K

Related Concept Videos

Coriolis Force01:23

Coriolis Force

An accelerating particle experiences a force equal to the mass multiplied by the acceleration in an inertial frame of reference. Consider a particle in a non-inertial frame of reference, such as a sliding ball on a rotating table. The acceleration of the ball in this rotating reference frame is different than in the intertial frame, which modifies its equation of motion. The fictitious forces acting additionally on a rotating frame of reference alter Newton's Second Law expression.
7.7K
¹H NMR: Interpreting Distorted and Overlapping Signals01:02

¹H NMR: Interpreting Distorted and Overlapping Signals

Spin systems where the difference in chemical shifts of the coupled nuclei is greater than ten times J are called first-order spin systems. These nuclei are weakly coupled, and their chemical shifts and coupling constant can generally be estimated from the well-separated signals in the spectrum.
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are...
1.3K
Spin–Spin Coupling Constant: Overview01:08

Spin–Spin Coupling Constant: Overview

In bromoethane, the three methyl protons are coupled to the two methylene protons that are three bonds away. In accordance with the n+1 rule, the signal from the methyl protons is split into three peaks with 1:2:1 relative intensities. The methylene protons appear as a quartet, with the relative intensities of 1:3:3:1.
Qualitatively, any spin plus-half nucleus polarizes the spins of its electrons to the minus-half state. Consequently, the paired electron in the hydrogen–carbon bond must...
1.2K
The Quantum-Mechanical Model of an Atom02:45

The Quantum-Mechanical Model of an Atom

Shortly after de Broglie published his ideas that the electron in a hydrogen atom could be better thought of as being a circular standing wave instead of a particle moving in quantized circular orbits, Erwin Schrödinger extended de Broglie’s work by deriving what is now known as the Schrödinger equation. When Schrödinger applied his equation to hydrogen-like atoms, he was able to reproduce Bohr’s expression for the energy and, thus, the Rydberg formula governing...
47.2K
Non-conservative Forces01:17

Non-conservative Forces

Non-conservative forces are dissipative forces such as friction or air resistance. These forces take energy away from a system as it progresses. Unlike conservative forces, non-conservative forces do not have potential energy associated with them. This is because the energy is lost to the system and cannot be turned into useful work later.
Also unlike their conservative counterparts, they are path-dependent; where the object starts and stops does matter. For example, a grinding wheel applies a...
8.2K
Stability of structures01:14

Stability of structures

In mechanical engineering, the stability of systems under various forces is critical for designing durable and efficient structures. One fundamental way to explore these concepts is by analyzing systems like two rods connected at a pivot point, O, with a torsional spring of spring constant k at the pivot point. This system is similar in appearance to a scissor jack used to change tires on a car. In this case, the arms of the linkage (equivalent to the rods in this system) are entirely vertical,...
679