The perpendicular-axis theorem states that the moment of inertia of a planar object about an axis perpendicular to its plane is equal to the sum of the moments of inertia about two mutually perpendicular concurrent axes lying in the plane of the body.
Consider a circular disc of mass M and radius R lying along an x-y plane. The origin lies at the center of the disc, and the z-axis is perpendicular to the disc's plane. All three axes coincide at the disc's center. The moment of inertia of this...

Unlike carbon, water, and nitrogen, phosphorus is not present in the atmosphere as a gas. Instead, most phosphorus in the ecosystem exists as compounds, such as phosphate ions (PO43-), found in soil, water, sediment and rocks. Phosphorus is often a limiting nutrient (i.e., in short supply). Consequently, phosphorus is added to most agricultural fertilizers, which can cause environmental problems related to runoff in aquatic ecosystems.

The two theorems developed by Pappus and Guldinus are widely used in mathematics, engineering, and physics to find the surface area and volume of any body of revolution. This is done by revolving a plane curve around an axis that does not intersect the curve to find its surface area or revolving a plane area around a non-intersecting axis to calculate its volume.
For finding the surface area, consider a differential line element that generates a ring with surface area dA when revolved.

The direction in which the induced emf drives the current around a wire loop can be found through the negative sign. However, it is usually easier to determine this direction with Lenz's law, named in honor of its discoverer, Heinrich Lenz (1804–1865). Lenz's law states that the direction of the induced emf drives the current around a wire loop always to oppose the change in magnetic flux that causes the emf.
If a bar magnet is moved toward a coil such that the magnetic flux...

An ohmmeter is a resistance-measuring device. It works by applying a voltage to a resistor of unknown resistance and measuring the current across the resistor. The resistance value is deduced using Ohm's law. Usually, the standard configuration of an ohmmeter comprises a voltmeter or an ammeter. However, such configurations are limited in accuracy because the meters alter the voltage applied to the resistor and the current that flows through it.
Thus, for accurate resistance measurements, a...

The total work done on an object acted upon by multiple forces can be computed using two methods that give the same result. In one method, the work done by each force is first calculated. Then, those values are summed algebraically to calculate the total work done by all the forces. In the second method, the net force is first calculated by a vector sum of all the forces. Then, the work done by this force is obtained.
Since forces perpendicular to the displacement do no work, they do not...