Related Experiment Video
Updated: May 6, 2026

Design and Construction of an Urban Runoff Research Facility
Published on: August 8, 2014
Promoting late-fall establishment of tall fescue with artificial soil covers to minimise soil erosion
1Geochemical Sciences Branch, US Army Cold Regions Research and Engineering Laboratory, 72 Lyme Road, 03755-1290, Hanover, New Hampshire, USA.
Abstract:
Frequently, turfgrass seedings have been sown in the late fall, which usually results in a poor vegetative stand and the possibility of soil erosion the following spring. This study evaluates the effects of a spun-bonded polyester soil cover placed over a late-fall seeding on subsequent seedling growth and overwintering. Clemfine, Mustang, Rebel, and Rebel II cultivars of tall fescue (Festuca arundinacea Schreb.) were sown on a silt loam soil in late fall (on 17 October in 1989 and 19 October in 1990) and allowed to grow with and without a soil cover until June. In the spring the temperature under the soil cover was greater than 2°C warmer than the uncovered soil from mid-April through May. Over the winter, leaf and root weights showed no detrimental effects from being under the cover. Individual cultivars grown under the cover produced 2 to 11 times greater leaf yields and 38 to 270% better stand establishment than those sown on the exposed soil. However, plant winter injury was observed under the soil cover in small soil depressions which accumulated water originating from thawing. All cultivars had similar amounts of growth under the cover. However, leaf yields for Rebel were 30-55% less than the other cultivars when grown under the cover and this was probably related to a low seed germination rate. The covers also promoted weed growth, which comprised from 34-65% of total leaf weights and was found to be negatively correlated (r = -0.66) to the yields of the sown grass. The soil cover was found to be beneficial to improving the success of seedling establishment of late seedings of tall fescue in cold areas.
Related Concept Videos
Design Example: Maintaining Level of an Embankment
Frost Resistant Concrete
Introducing microscopic air bubbles into the concrete mix through air entrainment creates small voids that accommodate ice expansion, thereby reducing internal pressures and preventing cracking. The optimal amount of...
Hot Weather Concreting
Mitigating the heat increase in concrete can be economically achieved by shading aggregate stockpiles to prevent heating from solar radiation,...
Responses to Drought and Flooding
Curing Methods
Cold Weather Concreting
To counteract the negative impacts of cold weather, ensuring...

