Related Experiment Video
Updated: May 6, 2026

Assessing Differences in Sperm Competitive Ability in Drosophila
Published on: August 22, 2013
Frequency-dependent male reproductive success in a polycross of Douglas fir
1Canadian Pacific Forest Products, Tahsis Pacific Region, Saanich Forestry Centre, 8067 East Saanich Road, RR # 1, BCV0S1M0, Saanichton.
Abstract:
Frequency dependence of male reproductive success (RS) was investigated in a polycross of Douglas fir. We expect frequency-dependent RS in conifer polycrosses for two reasons. The first is the presence of "pollen chambers" in conifers, which limits the number of competing pollen grains and enhances the reproduction of poor males when at high frequency in the polymix. The second reason is the possibility of competitive interactions among pollen types, which generally gives more complicated patterns of RS. To measure frequency dependence, we performed four separate polycrosses with respective proportions of 1∶1∶1, 2∶1∶1, 1∶2∶1, and 1∶1∶2 of the same three males. Male RS was measured with isozyme markers in seed offspring, and three different estimation models were applied to the data. A general log-linear model detected frequency-dependent RS, but did not allow any specific characterization of its nature. A comparison of two more specific models, the first incorporating pollen chamber size and the second incorporating competitive interactions, indicated that competitive interactions were predominantly responsible for the observed frequency-dependent RS. The implications of frequency-dependent RS for forest tree breeding are discussed.
More Related Videos
09:55Observation and Quantification of Mating Behavior in the Pinewood Nematode, Bursaphelenchus xylophilus
Published on: December 25, 2016
09:09Protocol for Assessing the Relative Effects of Environment and Genetics on Antler and Body Growth for a Long-lived Cervid
Published on: August 8, 2017
Related Concept Videos
Frequency-dependent Selection
Mate Choice
Testing a Claim about Population Proportion
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
Testing a Claim about Mean: Known Population SD
Estimating a population mean requires the samples to be distributed normally. The data should be collected from the randomly selected samples having no sampling bias. The sample size needed to be higher than 30, and most importantly, the population standard deviation should be already known.
In most realistic situations, the population standard deviation is often unknown, but in rare circumstances, when it...
Testing a Claim about Mean: Unknown Population SD
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used;...
Formation of Species