Assessment and comparison of surface chemical composition and oxide layer modification upon two different activation...

This study investigated the effect of two different activation methods on the surface chemical composition of a CoCrMo-alloy. The activation was performed with oxygen plasma (OP) or nitric acid (NA). The surface physical-chemical properties were thoroughly characterized by means of several analytical techniques: X-ray photoelectron spectroscopy (XPS), time-of-flight secondary ion mass spectrometry (ToF-SIMS), zinc-complex substitution technique, contact angle, and interferometry. The surface modification was evaluated by assessing contamination removal, the "active" hydroxyl groups (OH-act) present at the surface, the metal oxide ratio (CoyO x (-) /CryO x (-) ) and changes in the chemical composition and topography of the oxide layer. XPS experimental data showed for both methods (OP and NA) a significant decrease of the carbon contents (C 1s) associated with contaminants and at the same time changes in the atomic composition of the oxide layer (O 1s). In addition, the O 1s XPS spectra showed differences between the percentage of OH(-) before and after OP or NA treatment, leading to the conclusion that both methods are effective for surface "cleaning" and activation. These results were further investigated and corroborated by ToF-SIMS analysis and zinc complex substitution technique. The general conclusion was that NA is more efficient in terms of contaminants removal and generation of accessible OH-act present at the surface and without altering the native metal oxide ratio (CoyO x (-) /CryO x (-) ) considered to be essential for biocompatibility.