Related Experiment Video
Updated: May 6, 2026

Swimming Performance Assessment in Fishes
Published on: May 20, 2011
The effect of water pH on swimming performance in rainbow trout (Salmo gairdneri, Richardson)
1Department of Zoology, University of British Columbia, V6T 2A9, Vancouver, B.C., Canada.
Abstract:
A Brett-type respirometer was used to measure the effect of water pH on swimming performance of rainbow trout (Salmo gairdneri). Variations in water pH between 6 and 9 had no measurable effect on maximum aerobic swimming speed. At water pH 4, 5, and 10, however, the critical velocity was only 55, 67, and 61% respectively of that recorded for fish in water of pH 7. Exposure to acid conditions increased coughing and breathing frequency. Acid exposure resulted in a decrease whereas alkaline exposure resulted in an increase in both whole blood and red blood cell pH. Blood gas and acid-base characteristics showed little change during swimming at ∼2.0 BL/second, but exhaustive swimming resulted in a marked and immediate drop in blood pH in fish in acid, alkaline and neutral water. The blood acid-base status was restored to resting levels after exercise in neutral and alkaline water, but the acidosis was maintained following exercise in acid water. Fatigue occurred earlier and blood lactate levels increased to a higher level in fish swum to exhaustion in acid or alkaline water, compared with fish in neutral water.
More Related Videos
03:50Effectiveness of the Air Stripping in Two Salmonid Fish, Rainbow Trout Oncorhynchus Mykiss and Brown Trout Salmo Trutta Morpha fario
Published on: September 16, 2018
16:21Quantifying Fish Swimming Behavior in Response to Acute Exposure of Aqueous Copper Using Computer Assisted Video and Digital Image Analysis
Published on: February 26, 2016
Related Concept Videos
Derivatives: Problem Solving
Osmoregulation in Fishes
Testing a Claim about Population Proportion
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
Testing a Claim about Mean: Known Population SD
Estimating a population mean requires the samples to be distributed normally. The data should be collected from the randomly selected samples having no sampling bias. The sample size needed to be higher than 30, and most importantly, the population standard deviation should be already known.
In most realistic situations, the population standard deviation is often unknown, but in rare circumstances, when it...