Related Experiment Video
Updated: May 6, 2026

Integrating a Triplet-triplet Annihilation Up-conversion System to Enhance Dye-sensitized Solar Cell Response to Sub-bandgap Light
Published on: September 12, 2014
Attempt to improve the performance of pyrrole-containing dyes in dye sensitized solar cells by adjusting isolation
Huiyang Li1, Yingqin Hou, Yizhou Yang
1Department of Chemistry, Hubei Key Lab on Organic and Polymeric Opto-Electronic Materials, Wuhan University , Wuhan 430072, China.
Abstract:
Four new pyrrole-based organic sensitizers with different isolation groups were conveniently synthesized and applied to dye sensitized solar cells (DSCs). The introduction of isolation group in the side chain could both suppress the formation of dye aggregates and electron recombination. Especially, when two pieces of D-π-A chromophore moieties shared one isolation group to construct the "H" type dye, the performance was further improved. Consequently, in the corresponding solar cell of LI-57, a short-circuit photocurrent density (Jsc) was tested to be 13.85 mA cm(-2), while 0.72 V for the open-circuit photovoltage (Voc), 0.64 for the fill factor (FF), and 6.43% for the overall conversion efficiency (η), exceeding its analogue LI-55 (5.94%) with the same isolation group. The results demonstrated that both the size (bulk and shape) and the linkage mode between the D-π-A chromophores and the isolation groups, could affect the performance of sensitizers in DSCs in a large degree, providing a new approach to optimize the chemical structure of dyes to achieve high conversion efficiencies.

