Related Experiment Video
Updated: May 6, 2026

Carrier Lifetime Measurements in Semiconductors through the Microwave Photoconductivity Decay Method
Published on: April 18, 2019
Temperature dependence of Raman scattering in bulk 4H-SiC with different carrier concentration
Abstract:
Raman spectra of three bulk 4H-SiC wafers with different free carrier concentration were measured at temperature from 80 K to 873 K. As temperature increases, Raman peaks of most optical phonon modes show monotonous down shift. An anomalous non-monotonous variation with temperature, was observed in the A(1) longitudinal optical (LO) mode from doped samples. Two methods of theoretical fitting, one-mode (LO-plasma coupled (LOPC) mode) and two-mode (A(1)(LO) + LOPC) fitting, are employed to analyze this anomalous phenomenon. Theoretical simulations for temperature dependent Raman spectra by using two methods are critically examined. It turns out that one-mode method conforms well the experimental results, while two-mode method is untenable in physics. The non-monotonous variation of blue-red shifts with temperature for LOPC mode from doped 4H-SiC could be explained by the influence from ionization process of impurities on the process of Raman scattering. A quantitative description on temperature dependent Raman spectra for doped 4H-SiC is achieved, which matches well to experimental data.
Related Concept Videos
Carrier Transport
Drift Current:
The drift of charge carriers is started by an external electric field (E). Charged particles, such as electrons and holes, experience an acceleration between collisions with lattice atoms. For electrons, this results in a drift velocity (vd) given by:
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
Types of Semiconductors
Carrier Generation and Recombination
This process is given by the generation rate G and is efficient due to the conservation of momentum between the valence band maximum and conduction band minimum.
Indirect generation involves an...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...

