Comparison of stress-hemoconcentration correction techniques for stress-induced coagulation

Anthony W Austin1, Stephen M Patterson

  • 1Montreal Behavioural Medicine Centre, Hôpital du Sacré-Coeur de Montréal, Office J-3145, 5400 Boulevard Gouin Ouest, Montreal, Quebec, Canada H4J 1C5 ; Department of Exercise Science, Concordia University, Montreal, Quebec, Canada H4B 1R6 ; Research Centre, Hôpital du Sacré-Coeur de Montréal, Montreal, Quebec, Canada H4J 1C5.

When examining stress effects on coagulation, arithmetic correction is typically used to adjust for concomitant hemoconcentration but may be inappropriate for coagulation activity assays. We examined a new physiologically relevant method of correcting for stress-hemoconcentration. Blood was drawn from healthy men (N = 40) during baseline, mental stress, and recovery, and factor VII activity (FVII:C), factor VIII activity (FVIII:C), activated partial thromboplastin time (APTT), prothrombin time (PT%), fibrinogen, D-dimer, and plasma volume were determined. Three hemoconcentration correction techniques were assessed: arithmetic correction and two reconstitution techniques using baseline plasma or physiological saline. Area-under-the-curve (AUC) was computed for each technique. For FVII:C, uncorrected AUC was significantly greater than AUC corrected arithmetically. For PT%, uncorrected AUC was significantly greater than AUC corrected with saline or arithmetically. For APTT, uncorrected AUC was significantly less than AUC corrected with saline and greater than AUC corrected arithmetically. For fibrinogen, uncorrected AUC was significantly greater than AUC corrected with saline or arithmetically. For D-dimer, uncorrected AUC was significantly greater than AUC corrected arithmetically. No differences in AUC were observed for FVIII:C. Saline reconstitution seems most appropriate when adjusting for hemoconcentration effects on clotting time and activity. Stress-hemoconcentration accounted for the majority of coagulation changes.

Related Concept Videos

Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
837
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
818
Coagulation01:06

Coagulation

Colloidal solids are solid particles suspended in solution. They are usually negatively charged, attracting a compact primary layer of positively charged ions, which attract more counterions to form an electrical double layer. Electrostatic repulsion between the charged double layers prevents the particles from colliding, stabilizing the colloids. These solids are often undesirable because they can contain toxins that are difficult to remove. Coagulation is a technique that helps aggregate and...
1.5K
Introduction to Hemostasis01:05

Introduction to Hemostasis

Hemostasis is a complex physiological process that prevents excessive bleeding when a blood vessel is injured. It's crucial for maintaining the integrity of the circulatory system, as it ensures that our blood remains fluid while still within the vascular network and yet clots to prevent blood loss upon vessel injury.
The three phases of hemostasis involve many clotting factors present in plasma and several substances released by platelets and injured tissue cells. It is a fast, localized,...
14.3K
Anticoagulant Drugs: Low-Molecular-Weight Heparins01:30

Anticoagulant Drugs: Low-Molecular-Weight Heparins

Hemostasis is a crucial process that prevents excessive blood loss from damaged blood vessels. It involves various mechanisms such as vasoconstriction, platelet adhesion and activation, and fibrin formation. The importance of each mechanism depends on the type of vessel injury. In contrast, thrombosis is the abnormal formation of a blood clot within the blood vessels, leading to potential complications if the clot obstructs blood flow. Thrombosis can be caused by increased coagulability of the...
2.6K
Effects of EDTA on End-Point Detection Methods01:18

Effects of EDTA on End-Point Detection Methods

Different methods, such as visual observance of metal-ion indicators, spectroscopic techniques, and potentiometric methods, can determine the endpoint of an EDTA titration.
In the visual method, metal-ion indicators (metallochromic dyes), which have distinct colors in their free and complex forms, are added to the mixture to signal the titration's end point. They form stable complexes with metal ions, but these complexes are weaker than the corresponding metal–EDTA complexes. As a...
827