Evidence and recommendations to support the use of a novel passive water sampler to quantify antibiotics in...

A novel passive water sampler (diffusive gradients in thin-films for organics, o-DGT) was previously developed and successfully tested in the laboratory, but has not yet been validated in the field. Here, o-DGT samplers were deployed in the influent and effluent of a typical UK wastewater treatment plant (WWTP); the influent was also sampled with a conventional automatic sampler (Auto) and by grab (Grab) sampling. All the samples were analyzed by LC-MS/MS for 40 target antibiotics (including 16 sulfonamides (SAs), 12 fluoroquinolones, 6 macrolides, 2 ionophores, 2 diaminopyimidines, 1 aminocoumarin, and 1 lincosamide). The diffusion coefficients (D) of these antibiotics in o-DGT, measured in the laboratory, ranged from 0.58 × 10(-06) to 6.24 × 10(-06) cm(2) s(-1). The derived surface area normalized sampling rates (RS/A, 0.54-5.74 mL d(-1) cm(-2)) were comparable with those for another passive sampler called POCIS. Fourteen antibiotics were detected in the actively sampled water samples, with 10 of the 14 detected in o-DGT devices deployed for more than 7 days. Most of the antibiotics detected in o-DGT, except sulfapyridine, were continually accumulated by o-DGT for ~10 days. Deployment for 7 days is recommended to integrate ambient concentrations over time, without risks of reaching capacity and significant biofouling. Diffusive boundary layer (DBL) thickness had less effect on the o-DGT measurement than reported for other passive samplers. The comparison between o-DGT and Auto and Grab samplings showed that o-DGT was more efficient in terms of cost, time, and labor. This study demonstrates for the first time in a real environment that o-DGT is an effective tool for the routine monitoring of antibiotics in wastewaters and provides a powerful approach to studying their occurrence, fate, and behavior in the environment.