Related Experiment Video
Updated: May 6, 2026

Production and Measurement of Organic Particulate Matter in a Flow Tube Reactor
Published on: December 15, 2018
Adsorption of organic vapors on polar surfaces- Recent advances
1Ecological Chemistry and Geochemistry, University of Bayreuth, Post Box 101251, D-95440, Bayreuth, Germany.
Abstract:
This paper summarizes recent research on the adsorption of organic vapors on surfaces. Since the low gas phase concentration range is typical for environmental situations, this review is restricted to these adsorption coefficients.Two environmental parameters have a strong influence on the adsorption of organic vapors on polar surfaces:temperature andrelative humidity (which is the most suitable parameter for describing the influence of ambient moisture). An exponential relationship was found for the adsorption coefficientversus relative humidity and the reciprocal temperature, respectively. Comparing the heats of adsorption, two different groups of substances emerged: polar chemicals exhibited heats of sorption which were higher than their corresponding heats of condensation due to their ability to form hydrogen bonds, while for the nonpolar compounds the opposite was true. Sorption takes place on the surface of an adsorbed water film when the relative humidity exceeds the value which is necessary to form a monomolecular layer of water on the surface of the adsorbent (≥ 30 % relative humidity). Therefore, at temperature below 0 °C, a change in the adsorption behavior might be expected due to a change of properties of the adsorbed water film. However, no alterations were observed at temperatures from -12 °C to + 4 °C (adsorption on quartz sand). The results were comparable to those at much higher temperatures (50 - 80 °C).A statistical approach for the prediction of the adsorption coefficients from physico-chemical parameters of the substances (vapor pressure, polarizability, and electron-donating capability) was developed and good agreement was found with experimental results and independent data from the literature. Finally, two special cases, the adsorption on bulk water and ice, are discussed.
More Related Videos
12:05Preparation of Hydrophobic Metal-Organic Frameworks via Plasma Enhanced Chemical Vapor Deposition of Perfluoroalkanes for the Removal of Ammonia
Published on: October 10, 2013
11:38In situ FTIR Spectroscopy as a Tool for Investigation of Gas/Solid Interaction: Water-Enhanced CO2 Adsorption in UiO-66 Metal-Organic Framework
Published on: February 1, 2020
Related Concept Videos
Adsorption of Gases on Solids
Polymer Classification: Architecture
Radical Chain-Growth Polymerization: Overview
Polymer Classification: Stereospecificity
Adsorption Isotherms I
Polymer Classification: Crystallinity
Crystalline domains are the regions where polymer chains are aligned in an orderly manner and held together in proximity by intermolecular forces. For example, chains in the crystalline domains of polyethylene and nylon are bound together by van der Waals...