Data that are countable or measurable in specific units are called numerical or quantitative data. Quantitative data are always numbers. Quantitative data are the result of counting or measuring the attributes of a population. Amount of money, pulse rate, weight, number of people living in a town, and number of students who opt for statistics are examples of quantitative data.
Quantitative data may be either discrete or continuous. All quantitative data that take on only specific numerical...

In engineering applications, the representation of the numerical value is critical. Presenting or reporting the answer is one of the essential parts of engineering practices. Numerical calculations are performed using handheld calculators or computers since numerically accurate answers are always preferred.
The solution to a problem is obtained using different methods. While manually solving algebraic symbols is one of the most common methods, the graphical method is often preferred. Computers...

The concept of real numbers includes all the values that can be represented on a continuous number line. The system began with basic counting values used for enumeration. It later expanded to include values that represent the absence of quantity and opposites of the counting values. When situations required expressing parts of a whole or dividing quantities evenly, values capable of representing such proportions were developed. When written using decimal notation, these values can end or repeat...

All the digits in a measurement, including the uncertain last digit, are called significant figures or significant digits. Note that zero may be a measured value; for example, if a scale that shows weight to the nearest pound reads “140,” then the 1 (hundreds), 4 (tens), and 0 (ones) are all significant (measured) values.

The way a set of data is measured is called its level of measurement. Correct statistical procedures depend on a researcher being familiar with levels of measurement. Not every statistical operation can be used with every set of data. For analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
The data that cannot be measured but can be grouped into categories fall under the nominal level of measurement. Data that is measured using a nominal...

A bar graph is also called a bar chart and consists of bars that are separated from each other. It either uses horizontal or vertical bars to show comparisons among categories. The bars can be rectangles, or they can be rectangular boxes (used in three-dimensional plots). One axis of the graph represents the specific categories being compared, and the other axis shows a discrete value. In this graph, the length of the bar for each category is proportional to the number or percent of individuals...