How much confidence can be conferred on tectonic maps of continental shelves? The Cantabrian-Fault case

Fernández-Viejo Gabriela1, López-Fernández Carlos1, Domínguez-Cuesta María José1

  • 1Department of Geology, University of Oviedo. C/Jesús Arias de Velasco, s/n, 33005 Oviedo (Spain).

Scientific Reports
|January 14, 2014
PubMed

Related Concept Videos

Fault Types01:18

Fault Types

When analyzing a single line-to-ground fault from phase A to ground at a three-phase bus, it is important to consider the fault impedance. This impedance is zero for a bolted fault, equal to the arc impedance for an arcing fault, and represents the total fault impedance for a transmission-line insulator flashover. To derive sequence and phase currents, fault conditions are translated from the phase domain to the sequence domain.
For line-to-line faults occurring between phases B and C, the...
601
Yield Criteria for Ductile Materials under Plane Stress01:25

Yield Criteria for Ductile Materials under Plane Stress

In designing structural elements and machine parts using ductile materials, it is crucial to ensure that these components withstand applied stresses without yielding. Yielding is initially determined through a tensile test, which evaluates the material's response to uniaxial stress. However, tensile stress is insufficient when components face biaxial or plane stress conditions This condition requires advanced criteria to predict failure.
The Maximum Shearing Stress Criterion, also known as...
836
Confidence Intervals01:21

Confidence Intervals

An unbiased point estimate is often insufficient to predict a population estimate, such as population mean or population proportion. In this scenario, a confidence interval is used. A confidence interval is an estimate similar to a sample proportion. However, unlike the point estimate which is a single value, the confidence interval contains a range of values. These values have lower and upper limits, known as confidence limits, and can be designated as L1 and L2, respectively.
A confidence...
9.3K
Stress Concentrations in Circular Shafts01:18

Stress Concentrations in Circular Shafts

Consider the elastic torsion formula, which applies to a circular shaft with a consistent cross-section. This formula assumes that the shaft's ends are loaded with rigid plates firmly attached. However, in many cases, torques are applied to the shaft through mechanisms like flange couplings or gears, which are connected by keys inserted into keyways. This application method modifies the stress distribution near the point of torque application, causing it to deviate from the distributions...
739
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
834
Castigliano's Theorem01:18

Castigliano's Theorem

Castigliano's theorem analyzes displacements and rotations in elastic structures. It relates the derivative of elastic strain energy to the applied forces or moments, allowing for the calculation of deformations. The theorem states that the partial derivative of the total strain energy of a system with respect to a specific load results in the displacement at the point where the load is applied. This principle applies to both forces and moments.
1.4K