Estimation of genetic parameters in barley (Hordeum vulgare L.) : I. full, half and quarter diallel analysis

Four exotic and four indigenous strains of barley were used for making diallel crosses. The sets of parents and crosses making full, half and quarter diallel were analysed in a randomized block design for plant height, number of effective tillers, ear length, grain yield per plant, 100 grain weight and number of grains per ear.The three alternatives of diallel were similar with respect to the estimates of degree of dominance, general combining ability and specific combining ability, indicating that all these three methods of diallel were equally efficient. However, as the number of entries are minimum in quarter diallel, it would be economical in terms of cost, time and labour to estimate genetic parameters by this method. Average degree of dominance was found in the range of overdominance. The ranking of parents on the basis of their array mean was similar to the ranking based on gca effects. Similarly, the ranking of crosses on the basis of per se performance was similar to the ranking based on sca effects. This suggests that the selection of best general combiner or best cross combinations may be easier and more effective through array mean for per se performance rather than through high gca and sea effects, respectively. From among 56 crosses, IB-226 X X C-164 was the one which showed superiority for maximum number of characters followed by AB-12/59 X PTS-57. High sea effect for plant height, ear length, grain yield, 100 grain weight and number of grains per ear was the result of cross between parents having high X low general combining ability, indicating additive X dominance type of gene interaction. For number of effective tillers, high sca was produced by low x low general combiners, indicating dominance x dominance gene interaction.