Related Experiment Video
Updated: May 4, 2026

Utilizing a 3D Printed Laparoscopic Nissen Fundoplication Model to Shorten a Resident's Learning Curve
Published on: August 15, 2025
An objective comparison of novice trainees learning LESS versus traditional laparoscopy with the use of a pelvic
Gianmarco Isgrò1, Salvatore Micali, Giovannalberto Pini
1Urology Department, "Policlinico" Hospital of Modena, University of Modena and Reggio Emilia, Modena - Italy.
Objectives:
To compare the differences between LESS and SL among a population of subjects inexperienced of both techniques.
Materials And Methods:
Participants were randomly assigned to the LESS or SL arm of the course; between the population examined, none had previous laparoscopic experience. The trial consisted in performing three increasingly difficult exercises either with LESS or standard laparoscopy.
Results:
Time of execution and Objective Structured Assessment of Technical Skills score (OSATS) were recorded. Statistical analysis failed to detect any significant difference between the two arms of the trial. A trend in favor of standard laparoscopy was observed anyway.
Discussion:
Our study evaluates the technical performance on a surgical simulator in the laboratory setting, with the use of standardized tasks and validated metrics. We believe that a controlled and safe environment aids objective evaluation of LESS compared to SL. Literature on this particular topic is somehow conflicting and heterogeneous. Our trial demonstrated that novices performed LESS tasks without any additional difficulties compared to standard laparoscopy. The aim of such investigation is to support knowledge of this new technology in order to facilitate its use in selected patients and surgical procedures.
More Related Videos
09:51Model Surgical Training: Skills Acquisition in Fetoscopic Laser Photocoagulation of Monochorionic Diamniotic Twin Placenta Using Realistic Simulators
Published on: March 21, 2018
11:45Creation of a High-Fidelity, Low-Cost, Intraosseous Line Placement Task Trainer via 3D Printing
Published on: August 17, 2022