Related Experiment Video

Updated: May 4, 2026

Induction of Cerebral Arterial Gas Embolism in Rat
06:26

Induction of Cerebral Arterial Gas Embolism in Rat

Published on: October 18, 2024

1.0K

From the journal archives: cyclopropane: induction and recovery with a bang!

Michael P Bokoch1, Adrian W Gelb

  • 1Department of Anesthesia & Perioperative Care, University of California, San Francisco, 521 Parnassus Ave, C450, San Francisco, CA, 94143-0648, USA.

Canadian Journal of Anaesthesia = Journal Canadien D'Anesthesie
|January 15, 2014
PubMed
Abstract

More Related Videos

A Procedure for Studying the Footshock-Induced Reinstatement of Cocaine Seeking in Laboratory Rats08:54

A Procedure for Studying the Footshock-Induced Reinstatement of Cocaine Seeking in Laboratory Rats

Published on: January 6, 2011

22.3K
A Pressure Injection System for Investigating the Neuropharmacology of Information Processing in Awake Behaving Macaque Monkey Cortex09:46

A Pressure Injection System for Investigating the Neuropharmacology of Information Processing in Awake Behaving Macaque Monkey Cortex

Published on: March 14, 2016

8.2K

Related Concept Videos

Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes02:14

Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes

The low reactivity in alkanes can be attributed to the non-polar nature of C–C and C–H σ bonds. Alkanes, therefore, were  initially termed as “paraffins,” derived from the Latin words: parum, meaning “too little,” and affinis, meaning “affinity.”
Alkanes undergo combustion in the presence of excess oxygen and high-temperature conditions to give carbon dioxide and water. A combustion reaction is the energy source in natural gas, liquified...
6.2K
Cycloalkanes02:28

Cycloalkanes

Cycloalkanes are saturated cyclic hydrocarbons with carbon atoms arranged in the form of rings. They have two fewer hydrogen atoms than the corresponding acyclic alkane; therefore, their general formula is CnH2n. The structural formulas of cycloalkanes are simplified using the line-angle representation. The regular polygons are used to represent the cycloalkane rings, with each side representing a carbon-carbon bond.
The IUPAC nomenclature of cycloalkanes follows similar rules that apply to...
14.1K
Mass Spectrometry: Cycloalkane Fragmentation01:05

Mass Spectrometry: Cycloalkane Fragmentation

In mass spectrometry, cycloalkanes exhibit distinct fragmentation patterns due to the inherent stability of their molecular ions compared to linear or branched alkanes. The ring structure of cycloalkanes provides additional stability to the molecular ions, often resulting in prominent ion peaks in the mass spectrum.
For example, cyclohexane molecular ions have a mass-to-charge ratio (m/z) of 84, which tends to produce a stronger signal than linear alkanes like hexane. This stability comes from...
2.3K
Cycloaddition Reactions: MO Requirements for Thermal Activation01:16

Cycloaddition Reactions: MO Requirements for Thermal Activation

Thermal cycloadditions are reactions where the source of activation energy needed to initiate the reaction is provided in the form of heat. A typical example of a thermally-allowed cycloaddition is the Diels–Alder reaction, which is a [4 + 2] cycloaddition. In contrast, a [2 + 2] cycloaddition is thermally forbidden.
29.7K
Cycloaddition Reactions: Overview01:16

Cycloaddition Reactions: Overview

Cycloadditions are one of the most valuable and effective synthesis routes to form cyclic compounds. These are concerted pericyclic reactions between two unsaturated compounds resulting in a cyclic product with two new σ bonds formed at the expense of π bonds. The [4 + 2] cycloaddition, known as the Diels–Alder reaction, is the most common. The other example is a [2 + 2] cycloaddition.
2.4K
Cycloaddition Reactions: MO Requirements for Photochemical Activation01:12

Cycloaddition Reactions: MO Requirements for Photochemical Activation

Some cycloaddition reactions are activated by heat, while others are initiated by light. For example, a [2 + 2] cycloaddition between two ethylene molecules occurs only in the presence of light. It is photochemically allowed but thermally forbidden.
1.7K