Related Experiment Video
Updated: May 3, 2026

Genetic Mapping of Thermotolerance Differences Between Species of Saccharomyces Yeast via Genome-Wide Reciprocal Hemizygosity Analysis
Published on: August 12, 2019
Genetic correlation and response to selection in simulated populations : III. Correlated response to selection
R J Parker1, L D McGilliard, J L Gill
1Department of Dairy, Michigan State University, East Lansing, USA.
Abstract:
One of two quantitative traits was selected and correlated response in the other trait was measured in each of 30 generations for models of additive genes and of complete dominance. Each trait was controlled by 48 loci with equal effects, segregating independently from frequencies of 0.5 in the initial generation. Intensity of selection regulated the number of offspring from randomly mating 24 males and 24 females each generation. Three each of genetic correlations between traits, intensities of selection, and amounts of environmental variation were simulated.In the additive model correlated responses of the unselected trait to selection of the primary trait agreed closely with responses expected from theoretical considerations. In the model of complete dominance, responses of genotypic means of the unselected trait to selection of the primary trait in opposite directions were quite symmetrical for the first few generations but became distinctly asymmetrical in later generations. With little selection, response was fairly linear but became distinctly curvilinear as intensity of selection increased and environmental variance decreased. Between 15th and 30th generations some gains in the correlated trait to the 15th generation were lost.
Related Concept Videos
Frequency-dependent Selection
Hardy-Weinberg Principle
Mutation, Gene Flow, and Genetic Drift
Genetic Drift
Correlation and Causation
Correlation versus Causation
If the dependent variable increases or decreases when the independent variable increases, there is a positive or negative...
Coefficient of Correlation
If you suspect a linear relationship between x and y, then r can measure how strong the linear relationship is.
What the VALUE of r tells us:
The value of r is always between –1 and +1: –1 ≤ r ≤ 1.
The size of the correlation r indicates the...

