The relationship between running velocity and the energy cost of turning during running

Yoichi Hatamoto1, Yosuke Yamada2, Hiroyuki Sagayama1

  • 1Graduate School of Sports and Health Science, Fukuoka University, Fukuoka, Japan.

Plos One
|February 6, 2014
PubMed

Related Concept Videos

Kinetic Energy - II00:56

Kinetic Energy - II

The kinetic energy of a particle is one-half of the product of the particle’s mass and the square of its speed. Note that just as Newton’s second law can be expressed as either the rate of change of momentum or mass multiplied by the rate of change of velocity, so too can the kinetic energy of a particle be expressed in terms of its mass and momentum, instead of its mass and velocity.
6.4K
Velocity and Position by Graphical Method01:34

Velocity and Position by Graphical Method

Velocity and position can be calculated from the known function of acceleration as a function of time. The total area under the acceleration-time graph and the velocity-time graph gives the change in velocity and position, respectively. In the case of an airplane, its acceleration is tracked using the inertial navigation system. The pilot provides the input of the airplane's initial position and velocity before takeoff. The inertial navigation system then uses the acceleration data to...
9.3K
Energy Diagrams - I01:14

Energy Diagrams - I

The dynamics of a mechanical system can be easily understood by interpreting a potential energy diagram. Since energy is a scalar quantity, the interpretation of the dynamics of the system becomes even simpler.
Take the example of a skater on a parabolic ramp. The potential energy at different points along the ramp will be proportional to the height of the ramp, which varies quadratically with the horizontal position on the ramp. As the skater moves down the ramp from the highest position,...
4.2K
Energy Diagrams - II01:10

Energy Diagrams - II

Energy diagrams are important to understand the dynamics of a system. The topology of an energy diagram helps illustrate the equilibrium points of the system.
The point in the energy diagram at which the system’s potential energy is the lowest is known as the local minima. The system tends to stay in this position indefinitely unless acted upon by a net force. The slope of the potential energy diagram at the local minima is zero, indicating that zero net force is acting on the system. The...
11.1K
Work and Energy for Variable Forces01:10

Work and Energy for Variable Forces

When an object is acted upon by a variable force, the amount of work done and the change in energy of the object can be more complex to calculate compared to when a constant force is applied. Work is the product of force and displacement, while energy is the capacity of a system to do work. When a constant force is applied to an object, the work done can be calculated as the product of the force and the distance moved in the direction of the force. However, when a variable force is applied, the...
4.8K
Relative Velocity in One Dimension01:10

Relative Velocity in One Dimension

The understanding of the concept of reference frames is essential to discuss relative motion in one or more dimensions. When we say that an object has a certain velocity, we must state the velocity with respect to a given reference frame. In most examples, this reference frame has been Earth. For instance, if a statement reads that a person is sitting in a train moving at 10 m/s east, then it implies that the person on the train is moving relative to the surface of Earth at this velocity,...
9.6K