Related Experiment Video

Updated: May 3, 2026

The Evolution of Silica Nanoparticle-polyester Coatings on Surfaces Exposed to Sunlight
10:27

The Evolution of Silica Nanoparticle-polyester Coatings on Surfaces Exposed to Sunlight

Published on: October 11, 2016

8.7K

Roughness and optical losses of rugate coatings

T Herffurth, M Trost, S Schröder

    Applied Optics
    |February 12, 2014
    PubMed

    More Related Videos

    Convergent Polishing: A Simple, Rapid, Full Aperture Polishing Process of High Quality Optical Flats & Spheres13:07

    Convergent Polishing: A Simple, Rapid, Full Aperture Polishing Process of High Quality Optical Flats & Spheres

    Published on: December 1, 2014

    10.2K
    Impact of Fabrication Techniques and Polishing Procedures on Surface Roughness of Denture Base Resins03:02

    Impact of Fabrication Techniques and Polishing Procedures on Surface Roughness of Denture Base Resins

    Published on: January 17, 2025

    1.2K

    Related Concept Videos

    Shape and Texture of Coarse Aggregate01:25

    Shape and Texture of Coarse Aggregate

    Aggregate shape is classified based on the relative sharpness or roundness of the edges and corners. This classification includes categories like rounded, angular, elongated, and flaky, each with specific characteristics. Rounded aggregates, fully shaped by attrition, are typical of river or seashore gravel, while angular aggregates, such as crushed rock, have well-defined edges. Aggregates that are elongated and flaky are less desirable, as they can reduce the workability and strength of...
    1.3K
    Porosity and Absorption of Aggregate01:20

    Porosity and Absorption of Aggregate

    Aggregates contain pores of varying sizes; while some are completely enclosed within the particles, others open onto the surface, allowing water to penetrate. The porosity of aggregates is a major factor contributing to the overall porosity of concrete, given that aggregates constitute about three-quarters of concrete's volume.
    When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
    1.0K
    Major Losses in Pipes01:28

    Major Losses in Pipes

    When a fluid flows through a pipe, it experiences energy losses due to frictional resistance along the pipe walls, known as major losses. These energy losses result in a pressure drop, which varies based on the flow conditions — whether laminar or turbulent — and the specific physical properties of the fluid and pipe.
    Fluid flow can be classified as laminar or turbulent, primarily based on the Reynolds number. This dimensionless number reflects the relative influence of inertial to...
    2.1K
    Abrasion Resistance of Concrete01:23

    Abrasion Resistance of Concrete

    Abrasion resistance is an essential characteristic of concrete that determines its durability and longevity under various wear conditions. Concrete surfaces are vulnerable to different types of abrasion. For instance, surfaces may wear down due to the constant movement of vehicles or be eroded by solids carried in water, as seen in concrete canal linings. Specific tests are conducted to measure the abrasion resistance of concrete.
    One such test is the revolving disc test, where three plates...
    825