Effect of intraoperative weight-bearing simulation on the mechanical axis in total knee arthroplasty

Successful outcome after total knee arthroplasty (TKA) requires precise realignment of the mechanical axis. The intraoperative assessment of the mechanical axis is difficult. Intraoperatively, the effect of weight bearing on the lower limb mechanical axis is ignored. We developed a custom-made mechanical loading device to simulate weight-bearing conditions intraoperatively and analysed its effect on the mechanical axis during TKA.

Measurements of the mechanical axis were obtained during 30 consecutive primary TKAs in osteoarthritic patients using image-free knee navigation system. Half body weight was applied intraoperatively using our device to quantify the effect of intraoperative load application on the mechanical axis, thus receiving indirect information about soft tissue balancing. Furthermore, the intraobserver and interobserver reliability of navigated mechanical axis measurement with and without load was determined.

Before TKA, mean mechanical axis was 4.0° ± 4.9° without load. Under loading conditions, the mean change of the mechanical axis was 2.1° ± 2.8°. Repetitive measurements of the senior surgeon and junior surgeon revealed a high intraobserver (ICC 0.997) and interobserver reliability (ICC 0.998). The registration of the mechanical axis without and with application of intraoperative loading demonstrated no significant differences during insertion of the trial components (SD 0.29 ± 0.29) and after the definitive component cementation (SD 0.63 ± 0.44).

Intraoperative quantification and analysis of the mechanical lower limb axis applying defined axial loading by our custom-made loading apparatus is reliable. Ligament stability was unbalanced before TKA and balanced after TKA. For TKA, intraoperative simulation of weight bearing may be helpful to quantify, control and correct knee stability and its influence of mechanical axis.