Related Experiment Video
Updated: May 2, 2026

Reducing Willow Wood Fuel Emission by Low Temperature Microwave Assisted Hydrothermal Carbonization
Published on: May 19, 2019
Low temperature microwave and conventional heating pre-treatments to improve sludge anaerobic biodegradability
P Vergine1, J Zábranská2, R Canziani1
1Department of Civil and Environmental Engineering - DICA - Environmental Section, Politecnico di Milano, 32 Piazza Leonardo da Vinci, Milano, Italy
Abstract:
This paper presents the results of lab-scale experiments on low temperature thermal pre-treatment (less than 100 °C) prior to anaerobic digestion of sewage sludge. Two heating ways, microwave heating (MH) and conventional heating (CH), and two types of sludge, primary and waste activated sludge, were compared under the same experimental conditions. The degree of solubilisation produced by MH and CH up to 72, 82 and 93 °C was firstly estimated. For both types of heating, increase in soluble chemical oxygen demand (COD) caused by the pre-treatment was about 14% on waste activated sludge and only 3% on primary sludge. The final temperature of 72 °C resulted as the most cost-effective in terms of additional soluble COD per unit of energy required. Subsequently, five series of biochemical methane potential mesophilic assays were run in 120 mL serum bottles on sludge samples pre-treated at 72 °C. When compared with control reaction vessels, no significant differences were noticed in net methane production of pre-treated primary sludge, whereas a relevant increase occurred regarding the pre-treated waste activated sludge. It was also observed that the trend of methane content in biogas during the batch tests can be described by a second order polynomial.
More Related Videos
06:11Author Spotlight: Advancing Anaerobic Microbiota Research Using a Novel Respirometry Protocol
Published on: April 26, 2024
15:19Development of Sulfidogenic Sludge from Marine Sediments and Trichloroethylene Reduction in an Upflow Anaerobic Sludge Blanket Reactor
Published on: October 15, 2015
Related Concept Videos
Physical Methods for Controlling Microbial Growth: Temperature
Methods of Sterilization I: Physical Methods
Steam sterilization uses non-toxic, low-cost moist heat in the form of saturated steam under pressure, which is fast, microbicidal, and sporicidal, and quickly warms and penetrates fabrics. Autoclaves, or steam sterilizers, expose each item to direct steam contact for a predetermined time at the necessary...
Microbial Bioremediation of Hydrocarbons
Microbial Bioremediation of Plastics
Environmental Applications of Microorganisms
Biofuels