Meteorological influences on stemflow generation across diameter size classes of two morphologically distinct

John T Van Stan1, Jarrad H Van Stan, Delphis F Levia

  • 1Department of Geology and Geography, Georgia Southern University, Statesboro, GA, 30640, USA, jvanstan@georgiasouthern.edu.

Related Concept Videos

Xylem and Transpiration-driven Transport of Resources02:03

Xylem and Transpiration-driven Transport of Resources

The xylem of vascular plants distributes water and dissolved minerals that are taken up by the roots to the rest of the plant. The cells that transport xylem sap are dead upon maturity, and the movement of xylem sap is a passive process.
23.3K
Regulation of Transpiration by Stomata02:04

Regulation of Transpiration by Stomata

During photosynthesis, plants acquire the necessary carbon dioxide and release the produced oxygen back into the atmosphere. Openings in the epidermis of plant leaves is the site of this exchange of gasses. A single opening is called a stoma—derived from the Greek word for “mouth.” Stomata open and close in response to a variety of environmental cues.
26.2K
Introduction to Types of Flows01:23

Introduction to Types of Flows

Fluid flows are categorized by dimensionality and behavior, with one-dimensional flow being the simplest form, where properties like velocity and pressure change only along a single axis. Water moving through straight pipes exemplifies this flow type, as variations in other directions are minimal. One-dimensional analysis helps simplify understanding such flows, focusing solely on changes along the pipe's length.
Two-dimensional flow involves changes in both length and height, as seen in...
1.9K
Typical Model Studies01:30

Typical Model Studies

Fluid mechanics model studies often utilize scaled-down systems to predict fluid behavior in full-scale environments, such as river flows, dam spillways, and structures interacting with open surfaces. Maintaining Froude number similarity in river models is crucial, as it replicates surface flow features like wave patterns and velocities.
842
General Characteristics of Pipe Flow II01:24

General Characteristics of Pipe Flow II

When fluid enters a pipe, it first passes through the entrance region, where the velocity profile adjusts due to viscous effects. In this region, a boundary layer forms along the pipe walls and grows until it fully occupies the pipe's cross-section. Once the boundary layer merges, the flow becomes fully developed, with a steady velocity profile that remains consistent along the pipe's length.
The distance to reach a fully developed flow is called the entrance length and depends on the...
1.2K
Precipitation Processes01:12

Precipitation Processes

The experimental conditions in a gravimetric analysis should be optimized to maximize the particle size and purity of the obtained precipitate. Ideally, the concentration of the precipitating reagent should be low with effective stirring to maintain low relative supersaturation for the growth of large crystals. In homogeneous precipitation, the precipitant is slowly generated by a chemical reaction in the solution to avoid local reagent excesses. For example, urea decomposes gradually to...
5.0K