Concentrate: forage ratio in the diet of dairy cows does not alter milk physical attributes

Sandro Charopen Machado1, Concepta Margareth McManus, Marcelo Tempel Stumpf

  • 1FAI Faculdades, Rua Carlos Kummer, 100, Universitário, Itapiranga, SC, 89896-000, Brazil.

Related Concept Videos

Steady State Concentration01:05

Steady State Concentration

A steady state refers to the level of a drug in the body once it has reached an equilibrium between administration and elimination. It represents the point at which the drug administration rate equals the drug elimination rate, resulting in a relatively constant concentration in the body over time. The dynamic equilibrium is crucial to ensure the drug's effectiveness with minimal risk of toxicity.
Most drugs are administered in repeated doses at fixed intervals or through continuous...
5.9K
Solution Concentration and Dilution02:59

Solution Concentration and Dilution

The relative amount of a given solution component is known as its concentration. Often, though not always, a solution contains one component with a concentration that is significantly greater than that of all other components. This component is called the solvent and may be viewed as the medium in which the other components are dispersed or dissolved. Solutions in which water is the solvent are, of course, very common on our planet. A solution in which water is the solvent is called an aqueous...
113.3K
The Integrated Rate Law: The Dependence of Concentration on Time02:39

The Integrated Rate Law: The Dependence of Concentration on Time

While the differential rate law relates the rate and concentrations of reactants, a second form of rate law called the integrated rate law relates concentrations of reactants and time. Integrated rate laws can be used to determine the amount of reactant or product present after a period of time or to estimate the time required for a reaction to proceed to a certain extent. For example, an integrated rate law helps determine the length of time a radioactive material must be stored for its...
36.0K
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
834
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
813
Tonicity in Animals00:59

Tonicity in Animals

The tonicity of a solution determines if a cell gains or loses water in that solution. The tonicity depends on the permeability of the cell membrane for different solutes and the concentration of nonpenetrating solutes in the solution within and outside of the cell. If a semipermeable membrane hinders the passage of some solutes but allows water to follow its concentration gradient, water moves from the side with low osmolarity (i.e., less solute) to the side with higher osmolarity (i.e.,...
111.5K